Porter Cable Impact Driver Parts

This compression spring is for drills. The compression spring holds tension against the anvil and sleeve to keep the anvil tight on the armature. Disconnect the power before installing this part. Wear work gloves to protect your hands.

This is an OEM authorized part. It is sold individually. This spring maintains pressure on the N078437 Sleeve, and the rest of the bit holder assembly, to keep the bit in the holder. If this part fails the bit cannot be held in the bit holder. It is commonly used in impact drivers, and is compatible with the impact drivers listed below.

Genuine Dewalt replacement part, this item is sold individually. The N089668 Steel Ball is part of the chuck assembly of the Impact Drivers shown below. When you pull back the sleeve of the chuck assembly and insert your bit, the Steel Ball is the part that locks the bit in the chuck assembly.

This is a genuine OEM part sourced from the manufacturer. Sold individually. Washer provides a bearing surface for fastener load distribution or acts as a spacer. Is used in a number of impact drivers, listed below.

This is an authentic OEM replacement part, sold individually. The Hog Ring holds the bit holder assembly together, it is inserted in the very front of the sleeve. Without it the complete bit holder assembly would completely fall apart. Screwdriver is needed for repair. Compatible with the impact drivers listed below.

It is a genuine item that is supplied by the original equipment manufacturer for use with DeWALT, Black and Decker and Porter Cable impact wrenches. This is the special ring spring that is secured on the anvil, unfortunately, over time it will wear out, it may get damaged or lost eventually requiring a replacement. Make sure to check the diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality component is made of durable metal and is sold individually.

This is an authentic OEM part used in DeWALT and Porter Cable impact drivers. It fits between the anvil assembly and the sleeve. If it becomes lost or broken it will need replacing and a screwdriver may be needed during the installation. This part is made of urethane, a hard plastic, and is available individually.

Restore forward and reverse control with this red actuator for select cordless drills, hammer drills, impact drivers, and impact wrenches, a worn or broken actuator can feel stuck or stop the tool from changing direction, remove the battery before opening the tool, use the exact model and actuator color to confirm fit.

This is a genuine OEM replacement part used with the PCCK640LB (Type 1) 20V Impact Driver. The Porter Cable collar assembly is composed of metal and plastic items. This part secures the rubber sleeve to the motor & gearbox. The collar assembly is sold individually. A screwdriver and a pick set are helpful in the repair.

This is a genuine OEM part. The DeWALT sleeve is constructed of metal, and is compatible with several impact drivers. This component is fitted in the nose cone, between the spring and washer. The sleeve secures the anvil assembly and the spring. This part is sold individually. A hex key and a screwdriver may be helpful in the repair.