PCC641LB (Type 1) Porter Cable Impact Driver - Overview

This is an OEM authorized part. It is sold individually. This spring maintains pressure on the N078437 Sleeve, and the rest of the bit holder assembly, to keep the bit in the holder. If this part fails the bit cannot be held in the bit holder. It is commonly used in impact drivers, and is compatible with the impact drivers listed below.

This is a genuine OEM part sourced from the manufacturer. Sold individually. Washer provides a bearing surface for fastener load distribution or acts as a spacer. Is used in a number of impact drivers, listed below.

This is an authentic OEM replacement part, sold individually. The Hog Ring holds the bit holder assembly together, it is inserted in the very front of the sleeve. Without it the complete bit holder assembly would completely fall apart. Screwdriver is needed for repair. Compatible with the impact drivers listed below.

This compression spring is for drills. The compression spring holds tension against the anvil and sleeve to keep the anvil tight on the armature. Disconnect the power before installing this part. Wear work gloves to protect your hands.

This is a genuine OEM part. The DeWALT sleeve is constructed of metal, and is compatible with several impact drivers. This component is fitted in the nose cone, between the spring and washer. The sleeve secures the anvil assembly and the spring. This part is sold individually. A hex key and a screwdriver may be helpful in the repair.

Genuine Dewalt replacement part, this item is sold individually. The N089668 Steel Ball is part of the chuck assembly of the Impact Drivers shown below. When you pull back the sleeve of the chuck assembly and insert your bit, the Steel Ball is the part that locks the bit in the chuck assembly.

This is an OEM part sourced directly from the manufacturer. The switch assembly is found in a Porter Cable drill/driver. This part is a complete assembly, including a high-quality plastic trigger switch with plastic housing, metal connectors, and metal wires with flexible plastic coating. The switch is used to activate the machine. You will require a screwdriver when replacing this item.