XRSS665BB (PXRSS665BB0) Amana Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
crisper was cracked
0 of 1 people
found this instruction helpful.
-
donald from cameron, WI
- Really Easy
- Less than 15 mins
Pulled out old crisper. Took of the front and put it on the new crisper and slid it back in
Was this helpful?
Thank you for voting!
lower cam broke
0 of 1 people
found this instruction helpful.
-
Fonce from Ft Lauderdale, FL
- Really Easy
- 15 - 30 mins
-
Screw drivers, Socket set
Remove the grandkids pictures from the door then empty the contents inside the door. Remove the top hinge cover and the top hinge bracket. Lift the door off the bottom pivot. Replace the lower cam by removing one screw. With the door in the horizontal position, remove and replace the upper cam. Apply a little grease on both cam surfaces.
... Read more
Align the door before tightening the top bracket and your done. If you did not take a picture of the door before you started the project you will have to rely on memory to arrange the pictures in the proper location.
Read less
Was this helpful?
Thank you for voting!
Plastic Cams on frig door cracked in halk/door wouldn't close easily
0 of 1 people
found this instruction helpful.
-
Jim from Milford, MI
- Really Easy
- 15 - 30 mins
-
Screw drivers, Wrench set
Removed the top hinge (4 screws)-lifted the door off of the lower hinge-replaced both halves of the cam kit and mounted the door and reattached the upper hinge.
Probably took about fifteen minutes total.
Probably took about fifteen minutes total.
Was this helpful?
Thank you for voting!
The door clicked when opened or closed.
0 of 1 people
found this instruction helpful.
-
Donald from Mundelein, IL
- Easy
- 15 - 30 mins
-
Screw drivers
I followed the other web notes with one change .Since I too forgot the lube , I used a pry bar and block of wood to lift the door and a tooth pick to glob some lube in the lower hinge.
Was this helpful?
Thank you for voting!
Refrigerator door side lower closer cam broke
0 of 1 people
found this instruction helpful.
-
kent from fishers, IN
- Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
The worst part was unloading the door shelves. Removed upper hinge cover and hinge hex screws. This allows the door to be removed. Lay the door on side. Remove screw that holds cam in place. Replace
broken cam with new piece. Put the door back on the hinge pin and replace upper hinge screws and cover.
Now reload all of the stuf ... Read more f.
broken cam with new piece. Put the door back on the hinge pin and replace upper hinge screws and cover.
Now reload all of the stuf ... Read more f.
Read less
Was this helpful?
Thank you for voting!
drain hose burned and plugged
1 of 4 people
found this instruction helpful.
-
Barbara from Duvall, WA
- Easy
- 15 - 30 mins
-
Socket set
replaced drain hose; melted ice that had built up behind it
Was this helpful?
Thank you for voting!
cracked dairy door
0 of 1 people
found this instruction helpful.
-
Daniel from Dalas, TX
- Really Easy
- Less than 15 mins
parts select made it so easy.....great delivery in a short amount of time.
Was this helpful?
Thank you for voting!
the dairy door cracked within a week of the purchase
0 of 1 people
found this instruction helpful.
-
joseph from st paul, MN
- Really Easy
- Less than 15 mins
Within a 2 months of purchase the compressor on This refrigerator this unit failed. and again two years later. After all of that, we were pleased to find a replacement dairy door for this unit. thank you!
Was this helpful?
Thank you for voting!
crisper was broken
0 of 1 people
found this instruction helpful.
-
Robert from Saint Louis, MO
- Really Easy
- Less than 15 mins
replaced the crisper with a new one
Was this helpful?
Thank you for voting!
door snapping when opening and closing
0 of 1 people
found this instruction helpful.
-
robert from saint cloud, FL
- Really Easy
- Less than 15 mins
-
Socket set
removed top hinge, lifted door off bottom hinge, replaced cam, installed door.
Was this helpful?
Thank you for voting!
Main door was making a thunping noise when opened.
0 of 1 people
found this instruction helpful.
-
Don from Granbury, TX
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver, Screw drivers
Took the door off, and replaced the plastic shim on the bottom that was the cause of the problem. The shim had broken into pieces and was no longer holding the door in height and alignment. I was proud of myself that I could repair it myself and avoid a $125.00 service call from a repairman. Total cost of repair including shipping and ha
... Read more
ndling was just south of $12.00.
Read less
Was this helpful?
Thank you for voting!
Need a Crisper drawer, order the frame, sent it back and order the drawer. It on it way.
0 of 1 people
found this instruction helpful.
-
BettyeBettye from Florissant, CO
- Easy
- More than 2 hours
Just put the dairy tray were I wanted it. Will do the same with the crisper drawer when it arrives.
Was this helpful?
Thank you for voting!
The original frame had cracks
2 of 8 people
found this instruction helpful.
-
Leonid from Beaverton, OR
- Really Easy
- Less than 15 mins
-
Screw drivers
Replaced the frame
Was this helpful?
Thank you for voting!
ice build up in the dispenser chute
77 of 1254 people
found this instruction helpful.
-
Joe from Strongsville, OH
- Easy
- Less than 15 mins
-
Socket set
removed the spill tray, then two bolts. removed ice dispenser assembly by removing 3 more bolts. changed the seal and the insulation and reimstalled unit in hte reverse order. works perfectly -no more ice build up in the chute.
Other Parts Used:
Was this helpful?
Thank you for voting!
Refrigerator side will get warm
-
Maria from Indio, CA
- Easy
- Less than 15 mins
-
Nutdriver, Pliers
Went online to find a diagram for my particular model, found it, removed frezzer panel to gain access to the evaporator assy, performed a continuity test to the deffrost end cycle thermostat, found it open, ( out of range) on my dvom, at 25 deg., I should have had continuity, performed continuity test to heater assy. had continuity presen
... Read more
t, installed a new end deffrost cycle thermostat assy, tested, works great.
Read less
Was this helpful?
Thank you for voting!