EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

WRT17MB3AW2 Westinghouse Refrigerator - Instructions

All Instructions for the WRT17MB3AW2
91 - 105 of 321

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Handle broke off of door
2 of 2 people found this instruction helpful.
  • Don from MELBOURNE BCH, FL
  • Very Easy
  • Less than 15 mins
  • Screw drivers
New handle was easy to obtain from you and had the new one on in ten minutes. Thank you Very easy repaired.
Was this helpful?
Thank you for voting!
Freezer wasn't cooling - compressor not engaging
2 of 2 people found this instruction helpful.
  • Judy from ROYSE CITY, TX
  • Really Easy
  • 30 - 60 mins
Ordered the Capacitor and the Thermostat Control. Parts were received in a matter of a few days, easy to install, but did not fix the problem. Had to call a repairman to fix the problem (compressor relay - this part not available to order for this model number with Parts Select). Will continue to use Parts Select in the future for other p arts, but not happy that the actual part I needed was not available - had to use other methods.
Was this helpful?
Thank you for voting!
Refigerator not cooling
2 of 2 people found this instruction helpful.
  • Carlos from MOSINEE, WI
  • Really Easy
  • 30 - 60 mins
  • Screw drivers
I followed your video instructions, is very important to have this information.
Was this helpful?
Thank you for voting!
Condenser motor burned out
2 of 2 people found this instruction helpful.
  • Bill from STERLING, VA
  • Easy
  • 30 - 60 mins
  • Nutdriver, Socket set
I followed the instructions on your website, made it a simple as possible. Very tight work area sometimes fingers only, but a little patience works.
Saved at least $300. By not paying a repair person.
Was this helpful?
Thank you for voting!
Fan was off kilter and began rubbing the frame which is caused it to slow down and make an disturbing audible noise.
2 of 2 people found this instruction helpful.
  • Martin from N HOLLYWOOD, CA
  • Really Easy
  • 30 - 60 mins
  • Screw drivers, Socket set
Before buying the part, I watched your video and realized it was extremely simple to remove and replace. Item was to take 7-10 days and I received it in 4. Took longer than 15 minutes because I had to move the fridge forward, get my tools and a vacuum, get a cup of coffee and get to it. Very easy and the video was exactly step by step. It took longer to vacuum all of the dust bunnies than to replace the part.

Honestly, I was in the market to buy a new refrigerator but now I believe I'll wait several more years. Thank you for your support.
Was this helpful?
Thank you for voting!
the freezer frosted up and the fridge was not getting cold.
2 of 2 people found this instruction helpful.
  • Sherry from Newberry, SC
  • Easy
  • 30 - 60 mins
  • Nutdriver
I watched the instructional video and did what it said.
Was this helpful?
Thank you for voting!
Refrigerator too warm
2 of 2 people found this instruction helpful.
  • James from N RICHLND HLS, TX
  • Really Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers
The parts were easily replaceable. No special instructions needed. Just identify and remove and replace. I didn't know which specific part needed to be replaced (both reported to fix my problem) but neither part was very expensive so I replaced both. No special tools needed. 1/4" nutdriver and phillips head screwdriver. Repair took ab out 30 minutes. I did have to make an adjustment on the defrost timer (a small dial on the unit) I just set it how the old part was set. I immediately knew it was going to work when I plugged the refrigerator back in and the fan motor inside the freezer kicked on. Easy peesy...
Was this helpful?
Thank you for voting!
Refrigerator not working, freezer working
2 of 2 people found this instruction helpful.
  • Stephen from VAN WERT, OH
  • Easy
  • 30 - 60 mins
  • Nutdriver
I initially replaced the defrost timer, and later replaced it and the defrost thermostat. The defrost thermostat was the faulty component
Was this helpful?
Thank you for voting!
Frost in freezer, fridge not cold
2 of 3 people found this instruction helpful.
  • Bob from Pinole, CA
  • A Bit Difficult
  • 30 - 60 mins
From most posts I've read, the defrost timer was the culprit so I blindly ordered one. Easy install but did not fix the problem so I broke out the ohm meter. The only other 2 items it could be all tested good with my meter so I bypassed the defrost thermostat (per forum help...actually quite easy)and it defrosted fine, which told me I nee ded a new defrost thermostat. Installed fairly easy and problem gone.
Was this helpful?
Thank you for voting!
The refrigerator wasn't getting cold the freezer was getting to cold
2 of 3 people found this instruction helpful.
  • eddie from CHICAGO, IL
  • Really Easy
  • 15 - 30 mins
  • Screw drivers, Socket set
Followed the installation instruction for both parts now both the freezer and refrigerator are getting cold
Was this helpful?
Thank you for voting!
the refrig was in storage for about a year, the freezer door warped
3 of 6 people found this instruction helpful.
  • Jeffery from Phillipsburg, NJ
  • Really Easy
  • Less than 15 mins
removed freezer door and installed the new one. This was a pretty easy thing to do, although putting the old handle on the new door was a challenge. No knowing that there is a plastic piece holding the top of the handle i broke the that piece and had to order another one. Mean while the freezer was making alot of frost inside, so that had to be cleaned after the new part came.
Was this helpful?
Thank you for voting!
the freezer would stick in defrost and not come out
2 of 3 people found this instruction helpful.
  • carol from woodland, WA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Removed the vent cover at the bottom. Removed the screws. disconected the harnes and put the new timer in. This was a very easy fix. Thank You!
Was this helpful?
Thank you for voting!
first fresh food too hot, then freezer too hot
2 of 3 people found this instruction helpful.
  • Rita from Lake Luzerne, NY
  • Really Easy
  • Less than 15 mins
  • Nutdriver
Based on the website I decided it was most probably the defrost timer, and that was correct. I ordered it, watched the video, and two days later the part was at my door. Took the nut driver, removed 4 screws, then removed the old defrost timer, installed the new one, re-installed the whole plastic assembly with the four screws, and done !!! Couldn't have been easier.
Was this helpful?
Thank you for voting!
Broken door handle
2 of 4 people found this instruction helpful.
  • Mark from Apollo Beach, FL
  • Really Easy
  • Less than 15 mins
  • Screw drivers
The repair was relatively easy. What was surprising was the delivery of the part…ordered on Sunday and it was delivered by Tuesday morning. Wow, I was impressed!!!
Was this helpful?
Thank you for voting!
Defrost timer was not working
2 of 4 people found this instruction helpful.
  • Harold from Grants, NM
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Found the part on this site ordered and received part in 3 days. Took approx. 10 min to replace. Thanks for the quick service.
Was this helpful?
Thank you for voting!
All Instructions for the WRT17MB3AW2
91 - 105 of 321