- Home
- WRT15CSHW4
- Instructions
WRT15CSHW4 Westinghouse Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
freezer would frost up and not get cold enough to keep frozen.
3 of 3 people
found this instruction helpful.
-
Richard from SLIDELL, LA
- Very Easy
- 15 - 30 mins
-
Screw drivers
Removed shelves ,removed panel on interior back wall with Philips screwdriver ,unplugged wire terminals slid thermostat off coil ,then reversed process to complete installation.
Was this helpful?
Thank you for voting!
Freezer frosted up, refrigerator compartment heated up
3 of 3 people
found this instruction helpful.
-
James from Hanover, ME
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
I removed the housing at the top of the refrigerator compartment that contained the reefer light and temperature adjustment knob. This required a small nut-driver. Inside, I found the old defrost control, unplugged it, unscrewed it with a Phillips screwdriver, and replaced it with the replacement part. Then I replaced the housing to its o
... Read more
riginal position.
Read less
Was this helpful?
Thank you for voting!
Freezer too cold
3 of 3 people
found this instruction helpful.
-
Curt from Maple Grove, MN
- Really Easy
- 15 - 30 mins
-
Nutdriver
Removed the housing with the light, 4 hexhead screws. This exposed the defrost timer, removed 2 hexhead screws, electrical connector and reassembled the unit.
Great resource and service, thank you.
Great resource and service, thank you.
Was this helpful?
Thank you for voting!
Freezer wouldn't shut off and wouldn't reach cold enough temperature.
3 of 3 people
found this instruction helpful.
-
Tunis from NOLANVILLE, TX
- Easy
- 15 - 30 mins
-
Screw drivers
Removed existing part, tested it, found it to be defective. OrderEd a new one and replaced the existing one.
Was this helpful?
Thank you for voting!
Motor squeal
3 of 3 people
found this instruction helpful.
-
Mark from Partlow, VA
- Very Difficult
- 30 - 60 mins
-
Socket set
I didn’t do the repair because the new motor had a female pigtail connector while the original motor has male connection. It came with wire clamps but didn’t want to cut wires to make repair. The pictures online show a male connection. Put the old motor back in and now it works fine.
Was this helpful?
Thank you for voting!
Door Handle Broke off
3 of 3 people
found this instruction helpful.
-
Rosemarie from BOYNTON BEACH, FL
- Really Easy
- 30 - 60 mins
-
Screw drivers
Part arrived in tack.
Removed original screws. Place bottom of handle on sideways then horizontal position.
Next slightly raised top of handle over bump protector. Took orginial screw and screwd Top of door handle into place. Really easy!
Removed original screws. Place bottom of handle on sideways then horizontal position.
Next slightly raised top of handle over bump protector. Took orginial screw and screwd Top of door handle into place. Really easy!
Was this helpful?
Thank you for voting!
defrost heater not working; defrost timer not rotating so coils ice up
3 of 3 people
found this instruction helpful.
-
James from VOLANT, PA
- Easy
- 1- 2 hours
-
Nutdriver, Screw drivers
Checked for continuity in heater, defrost thermostat and defrost timer. Heater good; not sure about thermostat or timer. Replaced thermostat - no change. Replaced timer - rotating and heater working.
Was this helpful?
Thank you for voting!
The refrigerator wasn't cold enough.
3 of 4 people
found this instruction helpful.
-
John from San Diego, CA
- Really Easy
- Less than 15 mins
-
Screw drivers
I removed the plastic shroud on the ceiling of the refigerator, unscrewed and unplugged the old defrost timer, and replaced it with the new one. I reinstalled the shroud with the new timer installed.
Was this helpful?
Thank you for voting!
Freezer was freezing but refridgerator was warm. Checked fan and it was not turning.
2 of 2 people
found this instruction helpful.
-
Jerry from PHOENIX, AZ
- Really Easy
- 15 - 30 mins
-
Socket set
Unplug fridge. Removed 2 nuts to get the vent plate off and two more nuts to get the motor mount off. Removed fan blade and then the fan motor. I put the new motor in and put everything back as it was. It was very easy. I had items in the freezer, so I didn't turn the fridge off other than to replace the part. It took about 6 hours for t
... Read more
he fridge to reach optional temps because I didn't get to defrost and the fridge had to work it out on it's own. If you don't need the freezer then you should turn the refridgerator off for at least an hour and open the doors so the coils can defrost and any ice blockage between the freezer and fridge portion can melt away as well.
Read less
Was this helpful?
Thank you for voting!
broken door handle
2 of 2 people
found this instruction helpful.
-
Dennis K from LEEPER, PA
- Really Easy
- Less than 15 mins
-
Screw drivers
removed the two screws from broken piece and put handle in place and replaced the screws. easy-peasy.
Was this helpful?
Thank you for voting!
Someone broke ref. Door handle in garage, with car door!!!!
2 of 2 people
found this instruction helpful.
-
Marilyn from LOS ANGELES, CA
- Really Easy
- Less than 15 mins
Just screw new one on again. All done, like new
Was this helpful?
Thank you for voting!
4 broken drawer cover supports
2 of 2 people
found this instruction helpful.
-
Chester from STOCKTON, CA
- Very Easy
- Less than 15 mins
-
Screw drivers
Followed someone before me instructions. very simple and easy
Was this helpful?
Thank you for voting!
Handle broke off of door
2 of 2 people
found this instruction helpful.
-
Don from MELBOURNE BCH, FL
- Very Easy
- Less than 15 mins
-
Screw drivers
New handle was easy to obtain from you and had the new one on in ten minutes. Thank you Very easy repaired.
Was this helpful?
Thank you for voting!
Freezer wasn't cooling - compressor not engaging
2 of 2 people
found this instruction helpful.
-
Judy from ROYSE CITY, TX
- Really Easy
- 30 - 60 mins
Ordered the Capacitor and the Thermostat Control. Parts were received in a matter of a few days, easy to install, but did not fix the problem. Had to call a repairman to fix the problem (compressor relay - this part not available to order for this model number with Parts Select). Will continue to use Parts Select in the future for other p
... Read more
arts, but not happy that the actual part I needed was not available - had to use other methods.
Read less
Was this helpful?
Thank you for voting!
The original fan motor began masking a noise and finally stoped working.
2 of 2 people
found this instruction helpful.
-
Justin from FRANKLIN, TN
- Easy
- 30 - 60 mins
-
Nutdriver
Followed video instruction and completed the replacement. I had to join the wires since the connector was a male plug to a make plug.
Was this helpful?
Thank you for voting!