WRS20PRCD0 Frigidaire Refrigerator - Instructions

Replaced defrost timer & thermostat.

Ordered a new defroster timer and replace old one. It works just fine. A $35 repair vs a $500 new appliance.
Cool.
GWE

removed broken end caps, took a small screwdriver and simply applied a little pressure to release them. Pushed new end caps into place (they just snap in). Presto done!!

Inserted the caps into the bar and snapped in door. That's it.
No tools needed! Hope it last another 20 years

replaced it

removed drawer, removed front, slid in the front, put back in. done

Mount and dismount the part.

Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Bought a new drawer and just used the clear front from the broken drawer. Very easy to replace. Also fast delivery , thank you part select.

Put the new ordered door end caps in place, everything worked fine.

The end cap is easy to remove and replace. The personnel at PartSelect was extremely helpful in re-ordering the correct part.

The only problem I had was that the end cap was sent before the rack. This refrigerator is in our cottage and I brought up the end cap while waiting to receive the rack. I couldn't remember where I put the end cap, so when the rack came it took me a few weekends to find the end cap. Once I did, it took me less than 1 minute to repair. ... Read more I put the rack on the end caps & pushed the end cap in place. DONE!

Just removed the two screws and unpluged it.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.

First i pulled the crossbar off the door, then I pulled both end caps off the crossbar and then I
put the two new end cap on the crossbar and then tapped snoggly into place with the palm of my hand. Job done. took all of about 5 seconds.