WFC7500VW0 Whirlpool Washer - Instructions

This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.

Removed braces, then removed belt. Started the belt on, then when I got to a point that I couldn't turn it any more I put the cable tie over belt and wheel,tighten them as tight as I could. When the belt got about on I watched close if you don't it will come off going around motor.

I removed the rubber gasket, unscrewed the door latch, and removed from behind the gasket. It’s easily accessible from the front for removal and installation. However, it ran for two cycles normally, then displayed the code again.

Found a repair manual online. Followed instructions how to remove the door, front cover, took clamps off. Then attached the back side of the new bellow to the plastic drum, put clamp on and fasten the screw. Make sure the water draining hols are at the bottom (6 o'clock). Put the front cover back, screw everything back including the door ... Read more lock. Then attach the front of the bellow to the front cover, put the clamp on. Attache the door. That's it. I am a 49 years old woman. If I did it myself - anyone can do it!

Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discol ... Read more oring refer handles. Thank you