WDH2 (V3) Frigidaire Washer - Instructions

Followed video instruction and completed the replacement. I had to join the wires since the connector was a male plug to a make plug.

just had to loosen the old, broken piece, and snap in the replacement. Piece of cake

unplug power from ref removed old light socket only difference wired a little different checked new socket compaired to old checked terminal ends small big looked at wires big,little plugged up put in new light blub plugged ref power back on work power off pushed socket bac in power on works

I used a flat head screwdriver to pry open the front of the socket as I pushed the socket toward the freezer side. I unplugged the two wires connected to the socket then re-connected the two wires to the new socket and popped the new socket back in. I then put a new light bulb in and we had light again in the fridge.

Snapped in missing brackets, cut bar to fit and installed.

Replaced the old end cap with the new one. Took less than a minute.

Unplugged fridge, opened the door, used flat head screwdriver to pop off old switch, unplugged wires, plugged in new switch, popped it back in, and plugged the fridge back in. 2 minute fix.

snapped in the one end, placed the bar in one end and the other clip on the other end and snapped it in place.

Snapped the end caps onto the existing shelf, and eased the assembly into the door slots. Light tapping with a hammer was required to fully seat the assembly into the door. All in all, a straightforward and simple repair.

Removed assembly pieces
Remove screw and broken spring
Installed new spring from kit
Installed ice door
done

Simply unscrewed and removed the broken part and replaced it with the new part - took about 5 minutes.

replaced it

I read in another repair story how easy this was so decided to give it a try. I am a 57 yr. old female. I first removed the bottom glass shelf. I then unhooked the wire clips that held the drawer glide to the Support arms. I then unscrewed the four separate screws that attach the broken Support to the Refrigerator wall. I then screwe ... Read more d in the new Support. I repeated this process on the other side. I then replaced the drawer glide and re-hooked wire clips. I then inserted the drawer. 30 minutes tops including a little bit of cleaning.

Removed 3 screws and old part; then lined up new part and put 3 screws back. I was amazed that i could get a part for a refrigerator that is over 25 years old. Thanks!!!!!

Cleaned insert hole, did a dry-run, then pressed everything permanently in place.