VT910201 Campbell Hausfeld Compressor - Parts

This item is available as an individual replacement part. The belt goes around the pulley and is made of a durable material. A screwdriver might be necessary during the installation of this part. It will need to be replaced if it stretches or breaks. This genuine item is supplied by the original equipment manufacturer for use with Campbell Hausfeld compressors.

This is an OEM part made for use on Campbell Hausfeld air compressors. This rubber foot attaches to the bottom of the tank. It does not need special tools to repair. Simply slide onto the tank's bar. It stabilizes positioning of the compressor while protecting surfaces below. Sold individually.

This is a genuine replacement part for Campbell Hausfeld compressors. The strain relief screw is designed to fit around the head of a screw and prevent over tightening of the screw. The part is made of high-quality plastic. This item is sold individually.

This is a genuine item which is supplied directly from the original manufacturer for use with Campbell Hausfeld air compressors. This is one of the special self-tapping screws utilized to secure the wire belt guard. Unfortunately, over time they will wear out or might simply get lost eventually requiring a replacement. Please make sure to...Read more refer to the appropriate diagrams of your model for the exact location and application of this hardware. Keep in mind this high-quality screw is made of durable metal and is sold individually.

A genuine item which is supplied directly from the original equipment manufacturer for use with Campbell Hausfeld air compressors. The purpose of this gasket is to provide an air-tight seal for the inlet valve, over time it may wear out and even begin to crack eventually requiring a replacement. Keep in mind this high-quality component is...Read more made of durable composite material and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware.

The foam intake port plug goes between the inlet valve gasket and the filter screen and helps to clean the air. This is an OEM part sourced directly from the manufacturer and used in Campbell Hausfeld air compressors and is available as an individual replacement part. It is made out of a foam material and will need to be replaced when it ...Read morebecomes dirty. A socket set and a torque wrench may be required when replacing this part.