UT10562 Homelite Chainsaw - Parts

This fuel line is a high quality item that is specially manufactured for use with Homelite gas powered chainsaws. It is the inlet fuel line which is connected to an in-tank fuel filter delivering the fuel from the fuel tank into the carburetor. When you press the primer bulb, it will purge all the air out of the carburetor and fill its ch...Read moreambers with fuel. The excess fuel is then forced back into the tank through the return line which is sold separately. Over time these lines will become brittle and may crack eventually requiring replacement. Please note one durable flexible rubber fuel line is included per order.

(T20, M4 Torx)

This is an authentic Homelite replacement part that has been sourced from the original manufacturer to be used with chainsaws. The metal bolt fits into the saws chassis and is used to support the guide plates and bar. A hex wrench and a screwdriver may be needed for this repair. This bolt is sold individually, please note two bolts may be needed.

This part is sourced from the original equipment manufacturer for Homelite chainsaws. The spring applies tension on the connected components. It is an identical replacement for a faulty or a missing hardware that was installed on a new chainsaw. Refer to the appropriate diagrams for your model to ensure the correct repair procedure. This ...Read morehigh-quality lock spring plate is made of durable metal and is sold as an individual item. A screwdriver and a wrench set will be needed to perform this repair.

This authentic OEM sourced part is specially made for use with Homelite chainsaws. It is an identical replacement for a missing or a faulty guide bar plate that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. This high-quality plat...Read moree is made of durable metal and is sold individually, keep in mind the inner plate and other hardware are all sold separately.

The purpose of this fuel line is to to supply fuel from the tank to carburetor. This is a genuine OEM sourced replacement part that is produced for Homelite chainsaws. Over time lines tend to deteriorate and crack eventually needing to be replaced. It is made out of plastic and it is sold individually. Please note the fuel filter is sold separately.

This is an authentic replacement part manufactured for use with Homelite chainsaws. The primer bulb inlet tube carries fuel from the bulb to the carburetor. This inlet tube sold individually please see model diagram for additional parts.

This is a genuine Homelite replacement part that has been sourced from the original manufacturer to be used with chainsaws. The special gasket is used to seal the connection between the carburetor insulator and the cylinder assembly. It is recommended to replace gaskets when servicing the chainsaw to ensure proper seals when the parts are reassembled. This gasket is available as an individual replacement part.