TM516M1 (P7816005W) Amana Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer door gasket needed replacement
5 of 7 people
found this instruction helpful.
-
Dominic from Rockville Centre, NY
- Easy
- 30 - 60 mins
-
Nutdriver
Decided to replace gasket with door in place on fridge Loosened and removed all gasket retaining screws from behind freezer gasket, including the door shelf. Removed and replaced old gasket with new. Positioning and holding door shelf a bit awkward so have another person hold in place for at least one screw. After this replaceing the r
... Read more
emaining screws becomes easy. Do not tighten completely until all screws are in place; then align gasket and alternate tightening. Check for snug fit against fridge and adjust if necessary.
Read less
Was this helpful?
Thank you for voting!
After years of wear the toe grill to our refrigerator cracked
6 of 12 people
found this instruction helpful.
-
Tony from Champaign, IL
- Really Easy
- Less than 15 mins
Pulled the old grill out of its two pressure clamps and inserted the new grill in the emptied retainers
Was this helpful?
Thank you for voting!
The lightbulb burned out
3 of 3 people
found this instruction helpful.
-
Jennie from ASHEVILLE, NC
- Very Difficult
- More than 2 hours
Replace the refrigerator lightbulb while traveling 88 mph then turned on the flux capacitor being carful not to get stuck in a worm hole. This allows you to fix the problem before it starts to go bad.
Was this helpful?
Thank you for voting!
The clips broke off our old one , I glued to many times
1 person
found this instruction helpful.
-
Jill from FALL RIVER, MA
- Very Easy
- Less than 15 mins
Opened new kickplate from pkg and snapped it on !! So happy
Was this helpful?
Thank you for voting!
The old seal was broken and leaking causing the freezer to ice up.
1 person
found this instruction helpful.
-
James from WILMINGTON, OH
- Easy
- 30 - 60 mins
-
Screw drivers, Socket set
The repair was straight forward and was not hard. You do almost need 3 hands as the reinstallation of the inner door panel can be awkward. The only issue that I have is that the new seal has a poor fit. While it was received folded over on itself, this was not the problem. The seal does not expand enough on one side to fully seal the door
... Read more
. It also has a very weak magnet. If the magnet was stronger, then maybe it would seal better. It does still leak to some extent. The seal that was removed had a stronger magnet that the new one does. I would include a photo, but this system does not allow me to add attachments. Overall, I'm pleased with the time that it took to get the gasket, and the ease of replacement, but am not satisfied with the quality of the sealing or the strength of the magnet that holds the door closed. I would rate replace as 8 out of 10, and part quality and how it works as a 2 on a scale of 10.
Read less
Was this helpful?
Thank you for voting!
Screws on the door of the dishwasher were very loose.
1 of 6 people
found this instruction helpful.
-
Kathryn from Carol Stream, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!
Was this helpful?
Thank you for voting!