This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.
This rivet is an inch and a half long. It is used for many washing machines, microwaves, refrigerators, dryers, and ranges. Use of this rivet requires a rivet tool.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer door gasket needed replacement
5 of 7 peoplefound this instruction helpful.
Dominic from Rockville Centre, NY
Easy
30 - 60 mins
Nutdriver
Decided to replace gasket with door in place on fridge Loosened and removed all gasket retaining screws from behind freezer gasket, including the door shelf. Removed and replaced old gasket with new. Positioning and holding door shelf a bit awkward so have another person hold in place for at least one screw. After this replaceing the r
... Read moreemaining screws becomes easy. Do not tighten completely until all screws are in place; then align gasket and alternate tightening. Check for snug fit against fridge and adjust if necessary.
Read less
Was this helpful?
Thank you for voting!
The lightbulb burned out
3 of 3 peoplefound this instruction helpful.
Jennie from ASHEVILLE, NC
Very Difficult
More than 2 hours
Replace the refrigerator lightbulb while traveling 88 mph then turned on the flux capacitor being carful not to get stuck in a worm hole. This allows you to fix the problem before it starts to go bad.
Was this helpful?
Thank you for voting!
After years of wear the toe grill to our refrigerator cracked
6 of 12 peoplefound this instruction helpful.
Tony from Champaign, IL
Really Easy
Less than 15 mins
Pulled the old grill out of its two pressure clamps and inserted the new grill in the emptied retainers