TC407W Jenn-Air Trash Compactor - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Directional Switch lever broke
-
Dick from Penn Valley, CA
- Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
The part was suppose to come with instructions, but did not. However, it was easy after reading the comments on-line, and discovering that the front cover had to be removed in order to expose the whole switch and wires. I did drop one of the mounting screws down the front of the compactor and was not able to recover it. So, I had to ma
... Read more
ke a trip to the hardware store for a replacement. They couldn't match the remaining screw but I found 2 similar ones with lock washers and nuts that worked just fine. I saved a $90 service charge and probably double the cost of the switch by doing it myself.
Read less
Was this helpful?
Thank you for voting!
compactor wouldn't compact
-
Tena from Parker, CO
- Easy
- 15 - 30 mins
-
Screw drivers
bought new gears, pulled it out and replaced the gears. wasn't very hard. I did expect a jenn-air to be better built (plastic gears really!) but for 30 bucks it is all better.
Was this helpful?
Thank you for voting!
broken rotary switch
-
john from red bluff, CA
- Really Easy
- 15 - 30 mins
-
Pliers, Screw drivers
remove drawer remove two phillip screws lift off front panel remove wiring and plug into new switch.slide switch through the hole in panel install nut reinstall panel screws and drawer job done.
Was this helpful?
Thank you for voting!
the compactor was stuck in the down position
-
Rod from Quincy, IL
- Easy
- 15 - 30 mins
-
Screw drivers, Socket set
Had to first raise the screw plate that compacts the garbage. Then had to turn the compactor over and remove screws holding the bottom plate on in order to get to the gears. Once that was done I removed the worn gears and the chain drive and replaced with the new gears and the chain. Put the unit back together and works like a new one.
... Read more
A $35 dollar fix for a unit that sells for around $900 today. Thanks to partslect for being able to help me with the parts needed. Not only did I save on a new unit but by doing this myself I saved around $100 in labor charges.
Read less
Was this helpful?
Thank you for voting!
Unit cycled when on switch operated and would not stop until Off switch was activated.
-
Gerald from Wickenburg, AZ
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers, Wrench (Adjustable)
Replaced the limit switch. This did not alter the problem. Took off the On/Off/Start switch and dissasembled. I found the the Start switch was stuck in the on position. I reassembled the switch mechanism assuring that the Red "ON" indicator moldings were correctly positioned and reassembled everything. The Compactor now works properl
... Read more
y. Need to add "Check the Start switch" to diagnosis.
Read less
Was this helpful?
Thank you for voting!