SHX68T55UC (09) Bosch Dishwasher - Instructions

Turned off power and water supply. Pulled dishwasher out. Disconnected the water inlet from the back left side. Swapped out the inlet valve. Wiped up the water in the bottom pan. Put dishwasher back and turned on water and power. Simple.

Followed You Tube video how to replace door handle caps and used above mentioned tool. Note: could not use a regular screwdriver.

Went to on line video and followed it. The old gasket came right out and the new one fit right in. Started at the top middle and worked the gasket in on both sides to make sure it was evenly spaced.

removed machine so left side water drain matrix was accessible, replaced that unit, reinstalled machine to its built-in location.

Replacement was fast and very simple. Was completed in less than 5 minutes.

popped off old spray arm from under the rack and put on new spray arm,
couldn't be any easier, 5 minute job, door closes easily now!

We followed the video and had no problems with leaks at all afterwards. The parts fit perfectly and the machine is working great again.

Removed the dishwasher from the cabinet, laid it on its side, removed the old pump/heater, installed the new and reinstalled the dishwasher. What made this a little more difficult is my dishwasher has a bottom to it that would be very difficult to remove, access to the pump is from the side! I have large hands, not much room to work!

Mistakenly opened covers for the drain pump. Had to put those covers back in place.
Heater and pump installed easily with a bit of careful maneuvering the plugs and plug housing from the exterior. Pump installed in place easily. Clamp fit perfectly.

Repair was simple once the problem was diagnosed with the inlet valve.
Most of the work was in disconnecting the necessary lines so the dishwasher could be removed from the cabinets to replace the bad valve. Replacing the valve was easy. Reinstalling the dishwasher was just the reverse of the removal. The replacement part matched ... Read more the original and solved the problem we had.

The repair was extremely simple. Just lined up and popped them on. No tools needed.

There were 5 rollers still in place so I used them to show me how to snap the replacement roller in place.

Really simple. You pull out the drain filter plate and pull the filter off the support and replace. I gave everything a good cleaning and put it back in place.

I bought replacement wheels.
I put them on the post, and they snapped onto the vertical post very easily. Job done.

Easily removed the old one by carefully pulling it and repeated this procedure to replace it. Total time took less than 15 minutes