EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

RWT350AW Haier Washer - Instructions

All Instructions for the RWT350AW
1 - 4 of 4

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
The water stopped draining.
8 of 10 people found this instruction helpful.
  • ILANA from NEW YORK, NY
  • A Bit Difficult
  • 30 - 60 mins
  • Pliers, Screw drivers
I emptied all the water with a cup and laid the washer down on its back on the bathroom floor, ( it is a portable), with a few small pots and rags handy to collect water, just in case.
I inspected the placement of the broken drain pump, I took photographs of all the wires placements and screws. I removed the broken drain pump pho tographing each step, then attached the new drain pump following each step in reverse and attached the 2 colored wires to the remains of the colored wires attached to the washer. I used electric tape to isolate and cover completely the exposed wires parts i joined. I then screwed everything back in place. I put the washer upright, connected the electrical cord and did a test. It is working great, and the water is draining well! It took me over 30 minutes, as the space under the machine, where the drain pump lodges, is quite tight and I needed a flash light.
Was this helpful?
Thank you for voting!
Washer wouldn't drain.
4 of 8 people found this instruction helpful.
  • GABRIEL from GANADO, AZ
  • Really Easy
  • 30 - 60 mins
  • Wrench (Adjustable)
Lifted up the washer from the bottom. Accessed the pump, unscrewed the motor and pulled off the rubber hose attached to the pump using a Phillips screwdriver and a wrench.
Reattached the hose and the mounting screws. Worked just fine.
Was this helpful?
Thank you for voting!
Off balance tub made banging noise during spin.
1 person found this instruction helpful.
  • Richard from Lewes, DE
  • Easy
  • 15 - 30 mins
  • Pliers, Screw drivers
Washer was making loud banging noise during spin cycle. I noticed that tub was off center within washer housing while turned off. Removed top and checked for springs used to hold tub centered in the housing. Found one spring loaded support rod (Dampin)that had a broken spring. Due to two different part numbers, PS4125965 and PS4125966 it required considerable time to order the correct part, no parts supplier was aware of the reason for two part numbers. I had to contact the engineering department of Haier to fine the correct item, one number is for the right side the other number for the left side of the washer tub. Part snaps in place in upper corner of the washer housing and in a slot at the lower edge of the tub. No tools required to install Dampin just a screwdriver to remove top of washer. Parts arrived two days after ordering, very good service.
Was this helpful?
Thank you for voting!
All Instructions for the RWT350AW
1 - 4 of 4