RTT14CBMBRCC General Electric Refrigerator - Instructions

per your instructions

We removed the old Drawer Cover and replaced it with the new one. The Refrigerator Door had trouble closing. So we inserted the 2 plastic washers as described in the directions enclosed in the packaging. It was pretty straight forward and an easy fix. Thank you Hot Point and Part Select. Pete and Bonnie, Brooklyn NY

all I had to do is remove the broken cover then replace the new one which only took about 2 minutes. It was so easy and it is a little more durable than the original one.

Removed the old pan cover, which lifts out very easily, and replaced with the new one. I had to install the two plastic washers, that came with the kit, at the bottom of the refrigerator door around the hinge pin. To avoid having to take the door off to install the washers, I cut a piece out of each washer big enough to fit onto the hinge ... Read more pin. I first lifted the door up and placed a support underneath and then I snapped the washers onto the pin. This was done so the door would close properly. Installation instructions were enclosed with the shippment. Installation was less than 15 mins.

removed the inside fridge electrical panel and swapped switches

Replaced the cover.

I took out the old cover and slid the new one in place. Unbeievably easy. The old cracked cover was palpably a poorer-quality item than the replacement. The box from PartSelect also included some rubber washers in case the new cover impeded door closing, but it did not. Thank you very much, PartSelect!

just had to slide old out slide new in

easy pry out, disconnect wiring, connect on new switch and press in switch.

Super easy, removed drawers, lifted shelf and pulled out. Reversed the process with the new one and ready for use. Found new shelf to be a more sturdy quality than factory install so should have done this replacement years ago when I cracked the shelf! Excellent service in matter of just few days to get product. Would recommend highly ... Read more .

We just pried off the fan blades and pushed on the new part. Could not have been easier. The rat has been permanently dipatched and, hopefully, that is that.

Removed broken cover and installed part from partselect, perfect fit, east install

Simply removed old broken part and inserted new. It was just too easy

took out the old one and slid in the new, it worked. It took about 3 mins. and now I have a much more efficient bottom shelf in my refrigerator. Thanks!

I loved with this thing for a loooooong time and finally made the decision to replace it (mind you this is a rental too) Got the part in a day, lobbed all the stuff off the old one and pulled the drawers out. Popped the new one in, put the drawers in and VOILA! Took me less than 5 minutes! These guys are the best!