All Installation Instructions for Hotpoint Range RF764005

Burner had burned out-needed replacement

Plugged it in. It fit!

Parts Used:

8 Inch Surface Burner Element

Linda from Pagosa Springs, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Threw away old parts!

Put bowl in and then slid rings around. Just like cleaning procedure. Easy. Thanks for your service.

Parts Used:

Drip Bowl - 6 Inch

Trim Ring - 6 Inch

Valerie from Ogden, UT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Old drip pans rusted out.

Range is 45 yrs old. New drip pans are different shape. This is only place which had them and VERY GOOD price. Delivery was quick, too!

Parts Used:

Drip Bowl - 8 Inch

Drip Bowl - 6 Inch

Joseph from San Antonio, TX
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Old very stained drip pan and rings

Simply removed old and inserted new. No tools necessary.

Parts Used:

Drip Bowl - 8 Inch

Drip Bowl - 6 Inch

Trim Ring - 8 Inch

Trim Ring - 6 Inch

Avril from Wasilla, AK
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

Was this instruction helpful to you?

rht. front element would not heat properly

I read parts select instructions and i was done in less than 30 minutes. Since 1988, this is the 1st. part that I had to replace. I now have parts select on my favorites list.

Parts Used:

Range Infinite Heat Switch Kit

Rod from Huron, OH
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

element heat wouldn vary

slid the range away from wall. disconnect power. removed back,compared switches and marked wires.installed new switch and wires.the adapter for the control knob was a problem it left the knob out futher than original i had to modify the plastic adapter and got it close enought! the most time spent was cleaning up the floor before putting the range back.

Parts Used:

Range Infinite Heat Switch Kit

Leonard from Winter, WI
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers

Was this instruction helpful to you?

Element burned into.

TURN POWER TO OVEN OFF AT POWER PANEL 1- Remove element: 2 screws ... cut wire at element because of burned area. 2- Crimp two new wire lug connectors onto wire and attach to new element with supplied screws. 3- Attach element to back of oven: 2 screws ... TURN POWER ON AGAIN AND TEST OVEN

Parts Used:

Bake Element

Erbin from Poquoson, VA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Plastic Insert for knob to long, had to use my bench grinder to cut it down

(Turn off the Power) Pull stove out, remove the 2 screws that holds switch in place, remove one wire at a time and install on new switch. Slip switch in replace 2 screws. Snap off about 3/4 of the shaft cut down plastic insert for knob, install knob turn on power and it works.

Parts Used:

Range Infinite Heat Switch Kit

Floyd from Warren, OR
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Oven light wire broken, damaged socket

Remove light bail, glass cover held by two nut screws. Pull socket, removed clips in back, replaced wire connectors, placed new socket in, then glass cover and bail. Wire connected in back, cover plate replaced.

Parts Used:

RECEPTACLE PUSH-IN

Patricia from Brandenburg, KY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers

Was this instruction helpful to you?

replace a burned out calrod unit

Simply unplugged the burned out one and plugged in the new one. It worked like a charm.

Parts Used:

Surface Element - 6" - 1325W

Albert R from Richmond, MO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Condo Had Very Old Drop In. Threw Away Drip Pans And Rings

Placed new ones on range. Exactly what I would do to wash them.

Parts Used:

Drip Bowl - 8 Inch

Drip Bowl - 6 Inch

Trim Ring - 8 Inch

Trim Ring - 6 Inch

Valerie from Ogden, UT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Range purchased in 1989. Broiler Element Support Broke.

Removed 2 sheet metal screws. Threw away old part. Replaced with new part secured with the same old sheet metal screws. Works perfectly. Actually it took longer to type this response. I was very pleased with Part Select. If I need another part you'll be hearing from me.

Parts Used: