PDW9980N00SS General Electric Dishwasher - Overview

(108)

Part #WD35X21041

If you are having trouble rolling your dish rack in and out, there could be an issue with the rollers or axles. Check the existing rollers and axles for any visible physical damage. Replace the parts if the rollers or their axles are damaged. These rollers attach to the dish rack allowing the rack to roll in and out with ease. This pack i...Read more

Read less

$42.78

Dishwasher Basket Assembly Silverware

(77)

Part #WD28X24469

This basket is part of a silverware basket that has 3 sections. This is the middle section of the basket.

$160.61

Complete Lower Service Rack Assembly

(67)

Part #WD28X25960

This complete lower rack assembly is a genuine replacement part designed for select GE dishwashers, including models sold under Hotpoint, Haier, Monogram, and Café brands. Engineered to securely hold plates, bowls, pots, and pans during the wash cycle, it ensures optimal water coverage and prevents breakage. Constructed from high-quality ...Read more

Read less

$44.23

Water Inlet Valve

(56)

Part #WD15X10014

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve open and close according to the desired amount of water needed.

$15.00

Upper Rack End Cap

(2)

Part #WD12X10184

This end cap is sold individually. It is the same end cap used on the right and left side, for both front and back. It attaches to the end of the upper rack slide rail, and prevents the rack from falling when being pulled out too far.

$79.64

Detergent Dispenser with Rinse Cap

(29)

Part #WD12X10163

This detergent dispenser assembly is attached to the inner door panel of a dishwasher. This part holds detergent and dishwasher rinse products in a covered container. If your dispenser will not open, close, dispense detergent properly, or the dishes are coming out of the dishwasher dirty, replacing this part can solve these problems. The ...Read more

Read less

Upper Rack Wheel

(1)

Part #WD35X21036

Comes with the axles.

$114.88

Lower Spray Arm - Gray

(15)

Part #WD22X10047

The lower spray arm is mounted to the bottom of your dishwasher tub, and it rotates and sprays water to clean the dishes in the lower dish rack. This spray arm is made of gray plastic, and is approximately 20 inches in width. The lower spray arm will not spin if it has become clogged with debris and hard water deposits from your dishwashe...Read more

Read less

$51.65

Tub Gasket

(25)

Part #WD08X10032

This gasket lines the inside cabinet in the dishwasher.

$16.05

Hinge Arm Link

(9)

Part #WD14X10009

The hinge link on your dishwasher connects the spring to the dishwasher door hinge. If the hinge link becomes cracked or damaged, you may not be able to shut or lock your dishwasher door properly. In this case, you will need to replace the hinge link. Pull out your dishwasher to inspect the hinge and spring, if the link is broken, it may ...Read more

Read less

$19.08

Rinse Aid Cap

(23)

Part #WD12X10122

This genuine rinse-aid dispenser cap is an original replacement part from GE, designed for use with GE dishwashers. It covers the rinse agent port and securely seals the dispenser to keep the rinse aid contained until it's needed during the wash cycle. The cap is commonly replaced if it becomes lost or damaged. No tools are required for i...Read more

Read less

Tine Retainer

Installation Instructions

(2)

Part #WD12X10116

This dishwasher retainer connects to the removable tine.

Manuals & Care Guides for PDW9980N00SS

Click to download

Install

Questions And Answers for PDW9980N00SS

Ask our experts a question about this model and we'll get back to you as soon as possible!

Sort by:

Mary - For model number PDW9980N00SS

January 29, 2023

How do I remove and clean filter(s)

Hi Mary, thank you for your query. Your dishwasher has two filters at the bottom: a large filter screen that catches large food particles, part number PS959277 and a smaller filter screen that catches fine particles, part number PS958919. We have attached a video that will assist you in removing the fine filter. To clean the filter, rinse it under running water. Use a soft-bristled toothbrush to get any chunks of stubborn food. Next, place it in a mix of warm water and vinegar. Finally, let this solution soak for at least 30 minutes. We hope this information helps!

4 people found this instruction helpful.

Was this helpful?

Dean - For model number PDW9980N00SS

August 9, 2023

Need to replace my upper rack and need to order it

Hi Dean, thank you for reaching out. The upper dishrack for your model is part number PS8690633. If you need help placing an order, customer service is open 7 days a week!

$304.24

Upper Dishrack Kit

Was this helpful?

Kelly - For model number PDW9980N00SS

December 1, 2022

Dishwasher drains but not completely

Hello Kelly, thank you for reaching out. If your dishwasher is not draining completely, we suggest that you check the following parts: check valve, drain pump, sump, sump filter, and drain tube. Please reach out to customer service if you need help placing an order, anyone will be happy to assist you. We hope that helps.

$22.52

Check Valve Flapper

$49.58

Sump

$45.07

Drain Tube Kit

$59.14

Sump Filter and Cover

Was this helpful?

Kelly - For model number PDW9980N00SS

December 1, 2022

What what buttons to push to manually drain the dishwasher?

Hello Kelly, thank you for your question! To force your dishwasher to drain, follow these steps: 1. Press and hold the start button for 3 seconds. 2. Listen for the draining sound and wait until it stops before checking to see if all the water has drained. 3. Repeat the process if there's any remaining water. Follow these steps to manually drain the dishwasher: 1. Remove all the dishes and silverware. 2. Turn off the power supply and water supply. 3. Remove standing water from the dishwasher. We hope this solves your problem!

Was this helpful?

Common Symptoms of the PDW9980N00SS

How this model fails, and the parts that fix it.

Leaking

Not cleaning dishes properly

Not draining

Door latch failure

Will not dispense detergent

Will not fill with water

Not drying dishes properly

Videos related to models starting with PDW9980N00SS

Watch our pros, then fix it yourself.

Replacing the Dishwasher Basket Assembly Silverware

Replacing the Water Inlet Valve

Replacing the Hinge Arm Link

Replacing the Detergent Dispenser with Rinse Cap

Replacing the Upper Spray Arm Bearing

Replacing the Circulation Pump Impeller Kit

Replacing the Drain Tube Kit

Replacing the Lower Spray Arm - Gray

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Lower wheel axles worn out

966 of 988 people found this instruction helpful.

Glen from Alpine, CA
Really Easy
Less than 15 mins

Simple repair... Great Company, quick shipping (in CA had it the next day). Quality parts, GE OEM!! And to top it off the lowest prices!!

Other Parts Used:

Was this helpful?

My wheels would not stay on the roller rack which made me dread having to put a dish in the rack.

752 of 762 people found this instruction helpful.

Michelle from Weddington, NC
Really Easy
Less than 15 mins

All I had to do is take out the rack, pop off the old wheels, place the new stud rollers on, then pop on the new wheels. So easy and now my dishes don't get chipped when I pull the rack out and push it back in. I wish I didn't wait so long to order new parts.

Other Parts Used:

Was this helpful?

Lower rack began rusting and wheels broke off.

540 of 744 people found this instruction helpful.

nathan from commerce, MI
Really Easy
Less than 15 mins

Pull old rack out, slip new one in!
One thing i did was order wheels and studs as i was unaware they lower rack came fully equiped with all wheels,studs, and flip up dish dividers. So if your replacing the rack no need to order the wheels! The diagram made it look as if you only et the wire rack and not all the added pieces.

Other Parts Used:

Complete Lower Service Rack Assembly