MWS445RFS2 Frigidaire Washer - Parts

This spacer is used in washers or a washer and dryer combo unit. Spacers are used to create space between cotter pins, lock nuts, hitch pins or to fill the space between machinery parts in a washer. This part goes between the timer knob and the dial in a washer to function effectively and provide protection. The length of this part is 6.3...Read more5 inches with a width of 5.25. The spacer has a height of 8.125 inches and the weight of 0.3 pounds. Refer to the manual provided by the manufacturer for further installation instructions and guidance. Remember to unplug your appliance from the power source.

The capacitor is used on the washer motor to help the motor get up to speed quickly before transferring power to the run capacitor.

This is the bolt (screw) that holds the agitator in place.

This water inlet hose is used in washers. The hose connects the washer water inlet valve to the water supply in your home. There are two solenoids on the valve, which are referred to as coils, and there are two wires attached to each solenoid that should be labelled to ensure they are properly reconnected after replacing the new hose. Ove...Read morer time, your hose can begin to leak which can lead to floods. Replacing your hose earlier on can prevent this problem. Refer to the diagram provided by the manufacturer for installation instructions. Remember to unplug your appliance from the power source before beginning this installation project.

Use in conjunction with the agitator screw.

This clip is less than an inch long.

This part helps with the spinning and agitating cycles.

Appliance requires 2. Sold Individually. They are located on top of the service panel to be able to attach it to the main frame of the washer.

This part goes on top of the agitator.