MWS445RFS2 Frigidaire Washer - Parts

The spin bearing, used for your washer, is located at the bottom of the outer tub near the transmission. The spin bearing carries the transmission shaft in the drive system, therefore ensuring the shaft is spun properly during its spin cycle. If your spin cycle makes loud or odd noises, replacing the bearing could be a solution to your pr...Read moreoblem. Refer to the diagram provided by the manufacturer for further installation instructions. As a safety precaution make sure to unplug appliance from the power source.

The upper spin bearing for a washer can solve many issues such as loud and odd noises, or leaking water. Replacing the spin bearing could solve these issues. The tools needed for this replacement are screwdrivers, a socket set, and a putty knife. To repair, first lift the top of the washer and remove the screws at the bottom of the front ...Read morepanel to pull away. Next, pull off the dispenser cover, cup, and agitator. Detach switch tube from the tub cover and remove tub cover, then use the 1/2 inch socket to remove the trunnion bolts and pull out inner tub. For the rest of the installation instructions, refer to the diagram provided by the manufacturer. Remember to unplug the appliance from the power source as a safety precaution.

This tension spring works in conjunction with the idler pulley. The spring is part of your top load washing machine assembly. The most likely reasons for needing to replace the tension spring is if you notice that your washer is not spinning or agitating, the drive belt has come loose, and the idler pulley is no longer secure. To access t...Read morehis part, you will need to remove the front of your washer. The spring is located underneath the bottom of the tub. This is a genuine OEM part that comes right from the manufacturer.

This part is used to activate the lid switch when the lid opens/closes.

Clamp used for hoses.

Sold Individually.

This 3/4 horsepower, two-speed drive motor is designed for top-load washing machines and includes a pre-installed pulley for smooth operation. It powers the drum during both agitation and spin cycles, ensuring optimal performance throughout the wash process. Commonly used to resolve issues such as a washer that won’t spin, drain, or agita...Read morete, this motor can also address symptoms like burning smells, unusual noises, or cycle interruptions. Professional installation is recommended for proper alignment and secure mounting.

Holds plated on Trunion .312-18 x 1.625.