My Orders
- Home
- MWL2047SW119
- Instructions
MWL2047SW119 General Electric Washer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Water Leaking Onto Floor At The Let Front Corner
-
Robert from Wilbur, WA
- A Bit Difficult
- 30 - 60 mins
Using the 1" putty, push in on the 2 clips holding the top of the washer. Lift top, exposing the top of tub. Remove old rubber seal from top edge of tub. To ease installation of new seal, stretch it over the edge of tub which tensions it, then start tucking the outer lip along the outside edge, tilting the seal towards the outside e
... Read more
dge until the seal is completely in its groove all around. I had to hold down on the seal to keep it from rolling off while I lowered the top back down. When the lid is down, push hard to engage the 2 clips that lock it down.
Read less
Was this helpful?
Thank you for voting!
Washer can drain but not spin, buring smell
-
Zhiyong from North Potomac, MD
- Easy
- 1- 2 hours
-
Screw drivers, Wrench set
Lay the washer on its side, unscrew three screw to loose the rotor, put the belt and screw the rotor back.
Was this helpful?
Thank you for voting!