- Home
- MRTG23V9RF0
- Instructions
MRTG23V9RF0 Frigidaire Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
evaporator coil kept freezing up, refridgerator warm.
186 of 209 people
found this instruction helpful.
-
Greg from Hanover Township, PA
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver, Pliers, Screw drivers
This was the second part I tried. The defrost timer was first, but that did not fix it. To do this I had to remove the ice maker and the back plate of the freezer. Then I defrosted the coil and cut the wires. stripped them back and installed the new thermostat. re-assembled and tested. has been working great ever since.
Was this helpful?
Thank you for voting!
Refrigerator would not run but interior light was on.
184 of 248 people
found this instruction helpful.
-
Bruce from Alton, IL
- Really Easy
- Less than 15 mins
-
Pliers, Screw drivers
I unplugged the refrigerator, then opened the door and removed four screws holding the plastic electrical panel to the interior top of the main refrigerator compartment and noticed the cold control was corroded badly, apparently from moisture in the panel. I ordered a new one from partselect.com. When it arrived the next day, I then pul
... Read more
led off the control knob, unclipped the cold control, unplugged the three wires to the control, then removed the styrofoam insulation blocks holding the thermocouple wire and then removed the thermocouple wire to complete the removal. I then reversed the process to install the new thermostat and control. That is repositioned the thermocouple wire, put the insulation blocks back to hold the wire, then replugged the three electrical wires, clipped the control back and pushed the control knob back on and finally screwed the panel back to the top of the main compartment and plugged the refrigerator electrical cord back in to provide current to the refrigerator. It immediately started up and ran fine. Total time - about 8 minutes.
Read less
Was this helpful?
Thank you for voting!
Broke a blade off of the fan
79 of 88 people
found this instruction helpful.
-
Milton from Camp Hill, PA
- Really Easy
- 15 - 30 mins
-
Wrench (Adjustable)
When cleaning the coils on your refrigerator always remember rule number 1, unplug it first. I was cleaning the coils and hit the fan blade while it was moving with a brush, thus breaking off one of the fan blades. I ordered a new fan and installed it in about 15 minutes. Very easy repair.
Was this helpful?
Thank you for voting!
The door shelf/bin broke and fell off
45 of 50 people
found this instruction helpful.
-
Phillip from Cary, NC
- Really Easy
- Less than 15 mins
I simply snapped in the new part. It took a few seconds. I would like to say that I found the part using the model number of the fridge. When I went to look at the description it said the part was 26 inches. The one I had was only 24 3/4 inches. I called you guys and was told that this was the correct part and to ignore the measuement.
... Read more
r />You were Right! the part fitted perfectly.
Read less
Was this helpful?
Thank you for voting!
Plastic frame broken
32 of 38 people
found this instruction helpful.
-
James from Owego, NY
- Really Easy
- Less than 15 mins
Lifted out old part, removed glass shelf and slid it into position in new frame. Reploaced the frame in refridgerator. Slid plastic storage bins into place. Job Done.
Was this helpful?
Thank you for voting!
Brand new refrigerator, but evaporator fan blade broken, causing considerable vibration and noise.
30 of 35 people
found this instruction helpful.
-
John from Morgantown, WV
- Really Easy
- Less than 15 mins
-
Wrench (Adjustable)
Really, really, really easy:
1.Unplug refrigerator (electrical safety).
2.Remove cardboard cover at bottom of refrigerator (two short self-tapping bolts) with a wrench.
3.Pull old fan blade off fan motor shaft (just held on by a compression fitting--no tools needed).
4.Push new fan blade on shaft.
5. Replace card ... Read more board cover.
6. Plug in refrigerator, write nasty letter to Frigidaire.
1.Unplug refrigerator (electrical safety).
2.Remove cardboard cover at bottom of refrigerator (two short self-tapping bolts) with a wrench.
3.Pull old fan blade off fan motor shaft (just held on by a compression fitting--no tools needed).
4.Push new fan blade on shaft.
5. Replace card ... Read more board cover.
6. Plug in refrigerator, write nasty letter to Frigidaire.
Read less
Was this helpful?
Thank you for voting!
broken and cracked bins
30 of 39 people
found this instruction helpful.
-
Ruth from Livonia, MI
- Really Easy
- Less than 15 mins
Replaced the old bins with the new bins...The most important part of the story was finding this website and locating and ordering the necessary components...that was amazing - a few clicks of the mouse and my new parts were on their way.
Other Parts Used:
Was this helpful?
Thank you for voting!
Refrigerator light was out
26 of 37 people
found this instruction helpful.
-
andy from Peshastin, WA
- Really Easy
- Less than 15 mins
-
Pliers, Screw drivers
Test the light socket first with a bulb that you know is good. If the light still does not come on, unplug the refrigerator, remove the switch by inserting a very small, thin, flathead screwdriver alongside it and pull the switch out slowly with your other hand. There are two wires there. Remove them gently with some needle nose pliers. I
... Read more
f you want to test to see if the switch is defective, take a insulated jumper wire, and attach it between the two wires. Plug the refrigerator back in and see if the light comes on. If the light does come on, replace with a new switch by re-attaching the wires and placing it back in the hole firmly.
Read less
Was this helpful?
Thank you for voting!
refrigerator would'nt cool
22 of 31 people
found this instruction helpful.
-
arthur from doral, FL
- Really Easy
- Less than 15 mins
-
Nutdriver
first i removed the four screws that hold the shelve in place disconnected the wire replace both diffuser-air,reconnected the wire and replaced the screws
Other Parts Used:
Was this helpful?
Thank you for voting!
plastic hook broke
16 of 19 people
found this instruction helpful.
-
Christina from Tacoma, WA
- Really Easy
- Less than 15 mins
just snap the new piece in place.
Was this helpful?
Thank you for voting!
Broken Fan Blade
15 of 17 people
found this instruction helpful.
-
Albert from Bristol, IN
- Really Easy
- 15 - 30 mins
-
Nutdriver
Pull refrigerator away from wall, being careful not to kink or break water line to ice maker, unplug refrigerator. Using 1/4" nutdriver, remove cardboard lower rear panel, bottom lifts out. Fan and motor are now directly in front of you, grasp the moter to stablize it, and using your other hand, pull fan hub from motor shaft. Be sure mot
... Read more
or shaft is clean before reinstalling new fan blade, press new bladr onto motor shaft, until center of blade is centered on outlet side of fan housing. spin blade by hand to insure clearance. Plug refrigerator in and observe operation of fan, refrigerator needs to be calling for cooling for this fan to operate. Reinstall cardboard panel and move refrigerator back into position.
Read less
Was this helpful?
Thank you for voting!
Shattered crisper pan glass
16 of 21 people
found this instruction helpful.
-
Stacia from Salem, OH
- Really Easy
- Less than 15 mins
I slid the new glass in place
Was this helpful?
Thank you for voting!
I broke the fan while cleaning the coil
13 of 15 people
found this instruction helpful.
-
Raymond from Houston, TX
- Really Easy
- Less than 15 mins
-
Nutdriver
The broken fan made my refrigerator sound like a lawn mower I pulled the refrigerator out of it's nook and disconnected the power, removed the back panel with my battery powered drill motor, slid the old fan off of motor shaft, slid the new fan back on ran it to make sure the problem was corrected. The entire repair took less than fifte
... Read more
en minutes and was as simple as it could be. Please be careful when cleaning your coil, as the fan is easily damaged if you should contact it.
Read less
Was this helpful?
Thank you for voting!
Bottom shelf on door cracked and broke
12 of 14 people
found this instruction helpful.
-
Jamie from Greensburg, PA
- Really Easy
- Less than 15 mins
I ordered the Door Shelf Bin from PartSelect.com on Friday and received it on Saturday!! I was shocked, but thrilled. The easy to use diagram helped me to pick the right part and I easily replaced the broken one. I have already started to recommend PartSelect.com I was so thrilled with their service!
Was this helpful?
Thank you for voting!
Not running
10 of 12 people
found this instruction helpful.
-
Kenneth from SAVANNAH, GA
- Really Easy
- Less than 15 mins
-
Nutdriver
After waiting over 2wks for my part to arrive, I purchased the part locally and made the repair the same day as I am still waiting for the part to arrive from you guys. Your customer service really needs improving. I paid for 2 day shipping, what a joke. I will be returning the part as soon as I receive it thanks.
Was this helpful?
Thank you for voting!