MP426CS (41AD426G995) MTD Trimmer - Parts

This is a genuine manufacturer approved replacement mulching door torsion spring designed for use with handheld trimmers/edgers. This spring helps the throttle trigger to retract. It is made out of metal and it is sold individually. Replacing this item you would need a screwdriver and pliers.

This is a high quality OEM supplied replacement hardware that is specially produced for use with lawn and garden equipment. It is a standard hardware that has multiple uses depending on the unit, please make sure to check appropriate diagrams for correct location and use of this screw. Please note one durable metal torx screw is included per order.

The metal spring goes between the e-clip and the plunger and helps to maintain tension. It is a genuine item that is supplied by the original equipment manufacturer for use with trimmers. This is a small part that will need to be replaced if it becomes lost or stretched and may require a screwdriver to install the spring. This is available as an individual replacement part.

It is an authentic OEM sourced part which is made for use with handheld trimmers. This is the special component which provides a tight fit for the outer spool. Unfortunately, over time the hardware may get damaged or lost eventually requiring a replacement. One durable metal retainer is included. Refer to the appropriate diagrams for your...Read more model for the exact location and the correct application. You may need snap-ring pliers to perform this repair.

The Recoil Spring is a silver, metal spring which attaches inside the starter assembly. It is used to wind the rope back around the pulley after it has been pulled. If broken, the starter rope will not retract and the part must be replaced. This spring is rated "Medium" difficulty to install and will requires a screwdriver, pliers and a wrench set.

The Clutch Drum is a silver, metal part used to transmit power from the engine to the drive shaft. Installation is rated "Medium" difficult and will require a screwdriver, wrench set, and torx wrenches. This part attaches to the clutch assembly. If broken, the clutch will slip and you will lose drive power. If this happens, the part must be replaced.

This is a genuine item that is supplied by the original equipment manufacturer for use with trimmers. The metal clutch goes between the clutch drum and the clutch washer. It helps to spin the cutting head and the flex shaft. It may require a screwdriver and a hammer for installation. This clutch is available as an individual replacement part and comes with a washer.

This genuine OEM sourced item is specially designed for use with gas powered lawn and garden equipment. This rope is part of the recoil starter mechanism which allows user to pull-start the engine. One durable nylon rope is included per order, please note the plastic grip handle is sold separately.

The foam seal is sold as two parts, one is made of plastic and the other is made of foam. They fit between the large spring and the bump head knob and help to prevent debris from entering the device. Pliers may be required to replace these parts. These genuine items are supplied by the original equipment manufacturer for use with trimmers.