MLY2256ADB Maytag Range - Instructions

easy replaced after giving proper model and serial numbers. They were very helpful sending pictures so i could choose which knob might work as they had two for the same model number. The person answering my call was very helpful. Also return of the wrong ones I ordered was easy and refund prompt. I would highly recommend this company. ... Read more Gail from Mo.

Removed what was left of the original clips. Pressed in the new clips and snapped in the themostat blub

Purchased a 1999 RV discovered the oven was misssing a rack and we were unable to use.
Located the part, ordering was easy. The rack arrived and fits perfect in the oven like it was made for it.

Thanks

snaped them into oven cavity attached temp bulb job complete

removed flare nut and the two screws pull coupler back put in new one

The igniter on our RV stove top failed after 4 years of operation. The repair took about 8 minutes and everything works fine.

Remove two black Phillips head screws from the top of the oven door and two black Phillips head screws from the bottom of the oven door which releases the door from the oven. Remove the two Phillips head screws that hold the handle and discard broken handle. Install new handle onto door and then replace the door. Easy!!!

Put new parts on & the only trouble I had , I had no ideal where the or how the Extension flash tubes went on had to take one of the burners off & looked it over & found out it had two little what I`ll call slices in it to put the tubes on after that it all went in place very easyly it all worked just fine

I ordered the two replacement burners. When they arrived I equipped myself with WD-40 spray, rubber mallet and a rubber gripper I used to use to open canning jars. Sprayed the WD-40 around the burner base and let it sit for 20 minutes. Made a mental note of the location of the sparker of the burner, to remember to put the new one in the s ... Read more ame way. Gathered my courage and gently wacked the burner with the mallet all around it. Then grabbed the burner with the gripper and gave it a firm ¼ circle twist counter clockwise. It came apart with no problem. Disconnected the two electric wires by slipping them off their sockets. Removed all the loose rust and cleaned around the burner. Reconnected the wires with the new replacement burner and dropped it in its place. Wiggled it a little until it fit back into its original location and twisted it ¼ circle clockwise. Done, just saved myself the price of a new stove! Note: There is no need to shut off the main gas valve.

The new grommets were NOT the correct parts, too big, so there was no repair.

First I turned the burner head counter clockwise, lifted it out and pulled the connectors off. Then I connected the connectors back on the prongs of the new burner head and placed it back on the gas line and turned the burner head clockwise. I then turned the pilot light and and tested the connection. It worked without any problems. I the ... Read more n proceed to replace the second burner head using the same steps as on the first burner head.

unscrewed old burner about a 1/4 turn counterclockwise. pulled old burner out. removed the 2 wires connected to the burner. attached said wires to new burner making sure to connect correct color wire to same post as old burner. put new burner back in stove and turned about a 1/4 turn clockwise.

Simple off/on installation.

So simple would be embarrassed to give any instructions; it is so self evident.

Removed screws from igniter cover, removed and replaced fron extension tube. Removed old knob and replaced. Replaced missing grommet. Saved other extension tubes as the old ones were still serviceable.