LRFC22760SW LG Refrigerator - Instructions

part fit into slot and screwed them down

(1) Gasket holder is quite simple. Remove snap-on trim to expose gasket. Identify upper and lower clips (white 1" long) that hold gasket holder into frame of fridge door. Gently pry out / remove with flat-headed screwdriver. Gasket holder will slide out frpm the gasket. Replace - make sure you get the cam facing the correct way at the t ... Read more op of the holder. This is a pretty easy repair, 20 minutes beginning to end. (2) RHS light switch failed - replaced both -- door hinge cap removes w/ a single appliance screw - switches are plug-in to the wiring assembly, and snap into place in the hinge cap.

I ordered and replaced the ice maker. To replace:

1. Go behind refrigerator and unplug electrical cord and turn off water supply.

2. In freezer locate electrical plug for ice maker. It has two tabs on the left and right side of it. Lift the tabs and pull the plug to disconnect it.

3. Remove the three screw ... Read more s, 2 on top and 1 on bottom of ice maker You can actually leave the screws in place if you loosen them sufficiently and lift the ice maker off of the screws and washers.

4. Install the new ice maker using the screws and plastic washers to secure it.

5. Plug the electrical connector for ice maker into the receptacle. Note: The plug only goes one way and is keyed with different shaped plugs and holes. The wires on my plug naturally fell upside down so I had to turn the plug 180 degrees to make it fit in the slot.

6. Turn on water and check for leaks.

7. Plug back in refrigerator and you should have ice in less than 12 hours.

Used a screwdriver to remove covers. Used a blow dryer to defrost coil in freezer. Cut zip tie and removed old controller assembly. Inserted new controller assembly and secured with zip tie. It took 24 hours for the fridge to cool completely. Now it works fine.

Used a screwdriver to take off broken clip and then used same screwdriver to replace with new clip. Very easy.

Lifted out the crisper cover, from the front, took the glass out, put the glass back in the new crisper cover, reinstalled. The door basket, just lift out and replace it with the new one.

Very simple installation.

After noting frost in freezer Right rail started to jam. Noted freezer door was closing crooked. Rail replacement resolved issue. It had been frosting up for some time so Rail must have been broken for a while. Check door seals they were not closing flush.

Pull off the grill cover and remove the 2 screws from the old part and simply screw in the new part. Don’t lose the screws there are no new ones with the new part. Replace cover.

Ordered new part, which was crisper frame. Removed old frame and replaced it. Cleaned crisper glass and set in place.

It was so easy I opened the package and took part right out and put it on the refrigerator and bolted it down and that's it.

Just slid out the broken drawer and slid in the new one. The web site was very user friendly and my drawer arrive in only a few days. THANK YOU SO MUCH!!!!

Went on line to see how difficult it would be to replace the valve. Through Google there was a video which showed in exact detail how to remove and replace the valve. Then went on line to find the replacement part which was readily available. The only problem was that the connection on the valve where the fill water enters the valve was l ... Read more arger than the old valve. To fix that I went to a local Ace hardware store and found a nut that would fit the valve connection. Also don't forget to use a compression ring to keep the fill line secured when replaced.
Over all it was very simple and was in my "pay grade"

Removed broken door basket and snap in replacement.
The ordering process was quick and effective and shipped quick. Perfect replacement part. The do great work

Hard time clipping it in

YOUTUBE
Made it so easy!