This lower holder cover is also known as a toe grille clip, or a kickplate clip. It is designed for use with refrigerators. The main purpose of this part is to hold the molding at the base of your refrigerator in place, it also makes removing the piece of molding simple. If you notice that the kickplate on your appliance is loose or will ...Read morenot stay in place you may need to replace one or more of these clips. This part is made of plastic, and it is sold individually.
This is a genuine replacement switch. It is a push button style switch that is designed for use in your refrigerator. When the door of your appliance is opened the switch is released, and the light comes on. When you close the door the switch is pressed in, and the light turns off. You may need a putty knife to remove your old switch.
This door stopper helps limit door movement to prevent overextension. Designed for durability and precise positioning, it supports controlled operation and long-term reliability.
This water tubing clip holds the water fill tube in place in your refrigerator. The water fill tube attaches and supplies water to the ice maker/water dispenser in your fridge-freezer. If the tubing is in working order, but is hanging loose inside the unit, the issue could be that the clip meant to hold it in place is broken. If this is t...Read morehe case, you should look to replace the clip. This clip is made of black plastic, and is just over half an inch long. This is a genuine OEM replacement part, and is sold separately.
This cover support reinforces and stabilizes protective panels or covers during operation. Proper support helps maintain alignment and durability. Replacing a damaged support restores structural integrity.
(1) Gasket holder is quite simple. Remove snap-on trim to expose gasket. Identify upper and lower clips (white 1" long) that hold gasket holder into frame of fridge door. Gently pry out / remove with flat-headed screwdriver. Gasket holder will slide out frpm the gasket. Replace - make sure you get the cam facing the correct way at the t
... Read moreop of the holder. This is a pretty easy repair, 20 minutes beginning to end. (2) RHS light switch failed - replaced both -- door hinge cap removes w/ a single appliance screw - switches are plug-in to the wiring assembly, and snap into place in the hinge cap.
The ice maker in freezer P/NO 5988JA0002Y would leak water and make giant ice block
5 of 8 peoplefound this instruction helpful.
Eric from SURPRISE, AZ
Really Easy
30 - 60 mins
I ordered and replaced the ice maker. To replace:
1. Go behind refrigerator and unplug electrical cord and turn off water supply.
2. In freezer locate electrical plug for ice maker. It has two tabs on the left and right side of it. Lift the tabs and pull the plug to disconnect it.
3. Remove the three screw
... Read mores, 2 on top and 1 on bottom of ice maker You can actually leave the screws in place if you loosen them sufficiently and lift the ice maker off of the screws and washers.
4. Install the new ice maker using the screws and plastic washers to secure it.
5. Plug the electrical connector for ice maker into the receptacle. Note: The plug only goes one way and is keyed with different shaped plugs and holes. The wires on my plug naturally fell upside down so I had to turn the plug 180 degrees to make it fit in the slot.
6. Turn on water and check for leaks.
7. Plug back in refrigerator and you should have ice in less than 12 hours.