LP25939 Murray Snow Blower - Parts

The washer goes between the bearing and the intermed sprocket. It is available as an individual replacement part. This item is an OEM from Murray, Snapper, and Simplicity for use in snowblowers. A wrench might be needed during the installation process. It is made of metal and will require replacing if it bends or breaks.

A genuine item which is supplied directly from the original equipment manufacturer for use with Murray and Snapper lawn and garden equipment. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check the appropriate diagrams for the correct location and use of this screw. Keep...Read more in mind this high-quality component is made of durable metal and is sold individually.

This is a genuine Murray, Snapper, and Simplicity part sourced directly from the manufacturer for use in snowthrowers. The clutch spring boot is made out of rubber. A set of pliers may be necessary during the installation of this item. It may become broken and will need to be replaced. This is available as an individual replacement part.

This gear case gasket is a genuine OEM replacement designed to seal the auger drive gear case in outdoor power equipment, helping prevent oil leaks while protecting internal gears from moisture, dirt, and debris. Manufactured from durable material suited for high-load and cold-weather conditions, it maintains proper gearbox sealing and in...Read moreternal pressure for smooth, efficient operation. It is an ideal replacement when a worn or damaged gasket causes oil seepage, contamination, or gearbox performance issues, helping extend the life and reliability of the drive system.

Bolt 3/8-16x.75 g5

Seal oil

This is an authentic OEM sourced replacement part that is intended to be used with snowthrowers from Murray, Snapper, and Simplicity. The auger flange attaches to the side of the auger housing. This item is used to support the auger shaft assembly. The flange is sold individually, please note two may be needed.

Snow clean out tool with brush

This is an authentic replacement part that has been sourced from the original manufacturer to be used with snowthrowers from Murray and Simplicity. The metal washer is used to provide spacing between the wheel and the axle bearing. This item is available as an individual replacement part.

This replacement screw is supplied directly from the original equipment manufacturer for use with Murray walk-behind lawn mowers. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this part. This is a high-quality co...Read moremponent which is made of durable metal and it is sold individually, the washer is included.

This is a genuine manufacturer-approved component which is specially made for use with Murray and Snapper snowthrowers. The purpose of this pulley is to apply tension to the belt. It provides an identical replacement for a missing or a faulty part that was installed on a new unit that was installed on a new unit. Please make sure to refer...Read more to the appropriate diagrams of your model for the correct location and application of this idler pulley. Keep in mind this high-quality component is made of durable materials and is sold individually.