KUDD2 KitchenAid Dishwasher - Instructions

we used hot water to soften the ends of the tube and then slid it onto the two ends of the parts in the dishwasher. It did take a little bit of "push" to get it on one end, but nothing we could not handle. I would say anyone with common sense and willingness to fix something them selves would have no problem. I would like to say the pa ... Read more rt I ordered was of good quality and saved me a lot of money.

followed the tutorial video and just removed the old one and the new one slipped right on.

Got it in one day! When I tried to put it on, it didn't seem to quite fit at first, but with a few sharp taps from my rubber hammer it went right on. Works perfectly. Took about a minute for the whole installation.

Tranfered wheels from old rack to replacement rack. Silverware caddy was a bit too big for the replacement. I gently bent the prongs on the rack a little and its fits perfect.

Spray arm receiver went on easily. Then delivery tube slipped on to proper place easily. Total time for repair was less than 5 minutes.
My biggest problem was getting the replacement parts. I ordered the parts on June 3. The Spray Arm Receiver was shipped that day. On June 10th when the delivery tube(showing in stock) still had not b ... Read more een shipped I called Customer Service. The warehouse that received my order was out of stock. The customer service rep transferred my order to another warehouse that had the delivery tube in stock and it was shipped that day. I received the delivery tube today, June 18.

I put a whirlpool tube on my Jen more dishwasher . Fits like a glove.

FIrst I shut the water and power off. I took 4 screws off bottom panels of dishwasher. Using pliers I move spring clip of the rubber valve. I disangage the hose and disconnected electrical connection ( two wires ) . Then using two open wrenches ( 3/4" and the other probably 13/16" - not sure ) disconnected the copper tubbing. I replaced ... Read more the valve i reverse order.I used teflon tape for sealing connections . Everything works good now.

Like the video showed but very hard to stretch tube over wider part on interior of top shelf. Read afterwards that hair dryer would have helped. Video should mention that. Bruised hands and wrists getting it on good.

I took out the bottom rack, turned it upside down, popped off the wheels and saved them and put on the new axles. It took a little doing to get the new axles snapped into place-they were stiff. I finally figured out how to use the pliers at the right angle to pop them on. Then the wheels popped right on and off I went.

Did not use the new parts. After removing the spray arm, found a screw out of place. Put the seal ring back in place and the screw back in the hole. Machine works like new.

I replaced the seals per the video instructions.

ReplacING the tube was not a big job but the old tube had come apart and pieces had lodged in the sprayer arm. I used a toothpick and nut pick to dislodge the pieces and restore full water flow.

Closed water supply--Turned circuit breaker off to dishwasher--removed lower panel on dishwasher--removed the two wires from water inlet valve--disconnected water supply line--removed angle fitting from old valve & installed in new valve--reinstalled new valve & connected water line & 2 wires--This fixed problem.
I ordered part 11:0 ... Read more 0 1/15/09--Recd. new one 10:30 next morning. VERY FINE SERVICE & PRICE from PARTS SELECT.COM--Thanks.

Repair was awful without instructions. Instructions were requested twice with no response. Attempted without instruction and broke the sleeve. Reordered but not through Partselect

Repair went exactly like the video i watched online. Perfect