KUDA22 KitchenAid Dishwasher - Instructions

Took the part to the rental house and took the old water delivery tube off by hand and installed the new water delivery tube by hand , it took less than 10 minutes and exactly the right part.

Put a little liquid dish washing soap on the inside of the tube, it slipped on very easily.

Replaced the tube. It was relatively easy although it did take a small bit of squeezing/reshaping the newer rubber tubing to get it to fit on the outlet (it was a bit snug.)

Took the old one off then used canola oil to put on the inside of the tube and it went on easy.

Warm rollers and holders in warm water for 2 min each slide on all done

slid old tube pieces off slid new hose on

Removed bottom rack and replaced axles and wheels, works just like new and did it without any assistance from my son or Husband.

Removed old water tube and replaced it with the new one. Hard part was logistically trying to put it below the rack and it obviously it had to fit very tight and it was quite difficult to get in place, but I did it! Thanks to your easy to use website and excellent service. I was proud of myself for doing the whole job start to finish, ... Read more and my husband was even more impressed. Only downside to that is that I think he'll be playing more golf, while I do the repair work from now on.

Very easily!! I am 19 years old and repaired the dishwasher for my grandmother in about 15 minutes. Great products.

Repair was fairly easy, had to swith the mounting bracket from the old valve no problem. Install reconnected the water and the dishwasher works great now!

After checking for blockages in the drain line and finding none, I disassembled the wash wand assembly and discovered a gasket that had really deteriorated. Since there was nothing else apparently wrong, I took a chance and went shopping for the gasket. None of my local stores could provided me one so I searched on line and found it at ... Read more Partselect. It had to be special ordered and that took a while, but when it arrived, I put the new gasket in and had a perfect dishwasher again for less than 15 bucks. The schematic I was able to print from your website was invaluable.

I was trying to avoid having to buy a new dishwasher before the holidays. I went on YouTube and found the dirty dishes may mean bad water inlet valve. So, I used my meter to see if the valve was bad and sure enough it was. I ordered the part from Part Select. Once I received the part I removed the old one. Be sure to put a towel down to c ... Read more atch the excess water. The bracket that came with the new prt was a different configuration, but i swapped the new with old and it worked. I addition to the valve being bad the dishwasher upper and lower arms were somewhat clogged. I looked online again and followed YouTube instructions to clean. The dishwasher is cleaning like it is new. I would recommend to anyone doing work on their dishwasher to use part select and thoroughly clean the upper and lower arm.

I placed the hose on one side after placing one end in boiling water. I placed the other end in the hot water and pushed it on.

Removed the old tube with the aid of a knife to cut one end off the fitting. Then I lubed each end of the tube with dish washing soap and slipped them on. Done in 10 minutes. Easier to do if the top rack is removed for better access to the hose connections.

All I had to do was remove the damaged hose and replace it with the new hose. It took all of 5 minutes. The dishwasher is working like new!