KEHC37 KitchenAid Microwave Oven Combo - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Broken Cook tray
0 of 1 people
found this instruction helpful.
-
Michael from Kansas City, MO
- Really Easy
- Less than 15 mins
Well the repair went Ok. The probelm happen on the following Monday. You see I ordered this part over the phone because I had to make sure it would arrive in time for Thanksgiving.
Was this helpful?
Thank you for voting!
broken meat probe
0 of 1 people
found this instruction helpful.
-
Daniel from Massey, MD
- Really Easy
- Less than 15 mins
My story isn't so much about the repair but the fine service from part select. My 1st order was lost at delivery at our house. Part select quickly corrected the mishap with no issues. This kind of service is much appreciated.
Was this helpful?
Thank you for voting!
Missing Retainer and screw
4 of 13 people
found this instruction helpful.
-
Jan from Edmond, OK
- Really Easy
- Less than 15 mins
-
Screw drivers
Simple - Removed oven door attached retainer with screw.Re attached door.
Whirlpool wanted three time the cost of the same parts The only shipping option was Fedex Overnight which was very costly.
Your prices are great "Parts Select".
Jan
Whirlpool wanted three time the cost of the same parts The only shipping option was Fedex Overnight which was very costly.
Your prices are great "Parts Select".
Jan
Other Parts Used:
Was this helpful?
Thank you for voting!
The oven shipped without a temperature probe.
0 of 2 people
found this instruction helpful.
-
jerry from rochester, NY
- Really Easy
- Less than 15 mins
Unwrapped the package, plugged the probe into the oven, stuck the other end into the chicken.
Was this helpful?
Thank you for voting!
KitchenAid over door would not close completely
1 of 6 people
found this instruction helpful.
-
Rodd from Portland, OR
- Easy
- 15 - 30 mins
-
Screw drivers
I first removed the door from the front of the oven according to instructions that I found on the Internet from others that have had similar problems. I then removed a total of 8 screws - 4 that were holding the door together, and 2 each for the two hinges that I replaced. After replacing the hinges, I re-installed the 4 screws and then
... Read more
guided the oven door back into place. It took probably about 20 minutes from start to finish, and the news hinges that I purchased solved the problem perfectly.
Read less
Was this helpful?
Thank you for voting!
air circulation fan assembly
2 of 11 people
found this instruction helpful.
-
JOHN from CANTON, OH
- A Bit Difficult
- 1- 2 hours
-
Screw drivers
Remove oven from wall, remove top and back covers.Remove old fan assembly. The new assembly fit right in and works great.
Was this helpful?
Thank you for voting!
Both outside door handles turned very beige
23 of 76 people
found this instruction helpful.
-
Howard from Boynton Beach, FL
- Easy
- 30 - 60 mins
-
Nutdriver
Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discol
... Read more
oring refer handles. Thank you
Read less
Was this helpful?
Thank you for voting!
Blower very loud noise, all the time.
-
william from Wellington, FL
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
Removed double oven from cabinet after removing the doors, placing it on a milk crate, needs two people, turned it slightly to access the rear panels, removed panels and lower of the 2 motors and installed new motor, replaced all panels. I now have to check to make sure it is turned on it is so quiet! We lived with this noise so long beca
... Read more
use the appliance repair people said it was very expensive, about $400.00 to replace the motor, we did it for under $100.00 !!
Read less
Was this helpful?
Thank you for voting!
oven would not heat up in bake or broil
-
Tom from Fallston, MD
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers
Removed oven from the wall. Take off back panel. Removed thermal overload thermostat. Replaced with new part and works great.
Was this helpful?
Thank you for voting!
Broken inner glass in oven door
-
Phil from Flemington, NJ
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
Like others said, the trick was getting the oven door off. If you don't have the instructions, here's how: Open the door all the way. Shine a flashlight on the hinge, and you will see an open hole about 3/16" diameter below the hingepin and toward the oven. With the door open, put a 5/32" allen wrench or any other comparably-sized meta
... Read more
l pin into the hole in each hinge. With the pins in place, close the door as far as it will go, which is almost but not quite fully closed. Put one hand under the door handle, the other hand under the bottom of the door, and pull the bottom of the door down and out. With maybe a little wiggling, it will come right out. That's really all there is to it! Taking out all the glass layers is straightforward; you don't need any instructions to see how to do it.
Read less
Was this helpful?
Thank you for voting!
I cracked the interior glass door by dropping a dish on it.
-
Raymond from WESTVILLE, IN
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
Removing the door was the first challenge but once the door was off it was a matter of disassembling the door to get access to the interior door. If you remove all pieces and line them up in the order that they are removed you have a good chance for success.
Was this helpful?
Thank you for voting!
range installer broke a screw off & busted the plastic piece
-
Christina from West Des Moines, IA
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers
Had to screw off old terminal block & screw on new one
Was this helpful?
Thank you for voting!
Two Bulbs Burned Out
-
Joel from New Braunfels, TX
- Difficult
- 30 - 60 mins
Took off the covers and replaced the little bulbs. Took a long time to figure out how to get the covers off. Bulbs were $26 apiece!
Was this helpful?
Thank you for voting!
fuse blew for the fifth time
-
Karen from Moffit, ND
- Really Easy
- 30 - 60 mins
-
Screw drivers, Socket set
I was able to convince a local mechanic that he could do this after watching it done four times. The most difficult part was unscrewing and taking out the oven to get to the back. He suggested since this has happened everytime I used the self-cleaning feature, that I cut a hole in the wall for easier access (tongue-in-cheek). The most
... Read more
difficult part was dealing with the extended warranty service plan - this is covered, but they could not find a technician to do this. Then I found out they don't pay mileage so who would want to come out to a rural ND ranch to repair an oven?
Read less
Was this helpful?
Thank you for voting!
Oven would not heat after self cleaning operation
-
Bruce from Des Moines, IA
- Easy
- 30 - 60 mins
-
Screw drivers
Removed trim strip from each side of oven, removed one screw from each side hat held oven in place and slid oven out of wall. Finally found the thermostat located on the back side of the oven after removing the sheet metal on back. replaced the thermostat and reversed the procedure. Only difficult part was locating the thermostat. I t
... Read more
hought it was on top, when in fact it was on the back. Pretty easy, really, and saved some cash in the process.
Read less
Was this helpful?
Thank you for voting!