KEBS14 KitchenAid Wall Oven - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
inner glass on oven door
-
RONALD from CHICAGO, IL
- Really Easy
- 15 - 30 mins
-
Screw drivers
I followed the instructions given and it was very easy
Was this helpful?
Thank you for voting!
Not Heating
-
Gayle from Shelby, AL
- Easy
- 15 - 30 mins
-
Pliers, Screw drivers
Removed wall oven from wall. Removed back cover. Unscrewed thermastat and removed old thermastat. Screwed in new thermastat and put back together.
Was this helpful?
Thank you for voting!
Inner oven door glass cracked during operation
-
Alexander M from McMurray, PA
- Easy
- 15 - 30 mins
-
Screw drivers
Remove the door from the oven by rotating the two hinge locks. Place on soft working surface with inside door facing up. Remove screws from side , bottom and top of door. Place screws in groups as they were removed, the heads are different. Do not mix screws. Rotate door so outer Glass front is now on top. Slowly remove inner panel by sli
... Read more
ding the outer glass panel towards bottom of door. Carefully remove inner portion of door with the two inner glass panels. Remove inner broken glass from innermost panel. replace with new glass and reverse operations to reassemble door. Make sure the white filler maaterial is back from edge of inner door glass or you will be able to see it from the front after reassembly.When all assembled, slide door back onto hinges relock hinges and you are ready to go.
Read less
Was this helpful?
Thank you for voting!
oven door would not close
-
Edward from San Antonio, TX
- Easy
- 15 - 30 mins
-
Screw drivers
The repair went well & the part came in on time for thanksgiving thank you
Was this helpful?
Thank you for voting!
Cracked oven door inner glass
-
michael from corona del mar, CA
- Easy
- 15 - 30 mins
-
Screw drivers
Not difficult, but there are several layers of glass, metal, and insulation inside this door. Keep track of where the screws go and have room to lay out all the layers. You'll reach the cracked inner glass last.
Was this helpful?
Thank you for voting!
Upper double oven would not heat following a power failure during the clean cycle
-
Layla from Carmel, IN
- Easy
- 15 - 30 mins
-
Screw drivers
I turned off the power from the circuit breaker. I then removed the doors and the trim package from around the oven. I slid out the oven and had my husband help me lower it to the floor. I removed the back covering and then removed the wires connected to the old thermostat. I unscrewed the old thermostat and replaced it with the new ther
... Read more
mostat. Did everything in reverse and it seems to be working very well. It took about 30 minutes total. Some sites suggested that a fuse needed to be adjusted/replaced. In this kitchen-aid double oven and I'm assuming whirlpools as well, the thermostat/fuse is one piece located on the back of the unit. It was very simple. The piece cost $47. Such a great investment of time and money. I had the piece in 2 days, without paying extra postage.
Read less
Was this helpful?
Thank you for voting!
range installer broke a screw off & busted the plastic piece
-
Christina from West Des Moines, IA
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers
Had to screw off old terminal block & screw on new one
Was this helpful?
Thank you for voting!
Two Bulbs Burned Out
-
Joel from New Braunfels, TX
- Difficult
- 30 - 60 mins
Took off the covers and replaced the little bulbs. Took a long time to figure out how to get the covers off. Bulbs were $26 apiece!
Was this helpful?
Thank you for voting!
Inner Glass Was Broken
-
Jane A. from Lake Forest, IL
- A Bit Difficult
- 30 - 60 mins
-
Pliers, Screw drivers
I followed the instructions for installation on your site. I encountered two problems. I was unable to unscrew several screws. I had to used wd40 and slight encouragement from a soft hammer. Also, I was glad for the advice in one instruction about paying attention to the type of screw (flat or more flat). Otherwise, when
... Read more
I was ready to put everything back together, I would have had some problems. The flatter screws definitely had to be used in certain areas.
Read less
Was this helpful?
Thank you for voting!
Cracked inner door glass
-
Mark from Ocean, NJ
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
A generic video on Youtube was actually very helpful as it showed how to remove the door from the oven for easier glass replacement. The only tricky part is getting the panes of glass in the correct order during reassembly,as there are actually 4 pieces in the door. Only the piece that faces the oven's interior was cracked on mine. The tw
... Read more
o inner pieces between the two outermost pieces are the ones not to mix up. This little repair also gave me the opportunity to thoroughly clean all 4 pieces of glass that had become rather dirty over 12 years. Now the oven door looks like new!
Read less
Was this helpful?
Thank you for voting!
Overn door hinge springs broke
-
Kevin from irvine, CA
- A Bit Difficult
- 30 - 60 mins
-
Pliers, Screw drivers
Took off the oven door, oven in wall mount, had to pull oven 80% out to access both end of spring holders, reattached springs, slide oven back into place, installed face-plate and oven door. The most difficult part was pulling oven out of wall, I did not know it would be that heavy.
Was this helpful?
Thank you for voting!
replace thermo fuse
-
mike from king city, OR
- Easy
- 30 - 60 mins
-
Screw drivers
turned breaker switch off. unscrewed the oven from the cabinet. lifted the oven out of the cabinet (heavy & awkward, needed an extra pair of hands). removed back panel. replaced fuse. reassembled everything. this is the second time i've had to replace the thermo fuse (oven blows the fuse when set to clean). first time i replaced the fuse
... Read more
it took about two hours. second time it about an hour.
Read less
Was this helpful?
Thank you for voting!
broken glass
-
Arleen from North Haven, CT
- Easy
- 30 - 60 mins
-
Screw drivers
followed the brief instuctions you provided easy as pie
Was this helpful?
Thank you for voting!