KDTM7 Dishwasher - Parts

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Sold individually.

Sold individually.

This is the replacement adjuster housing for your dishwasher. It is made of gray plastic and is approximately 4X4 inches. The adjuster housing clips into the dish rack and allows you to adjust the height of the rack. Because it is made of plastic, the housing can occasionally break. When this happens you may notice that one side of your d...Read moreish rack is lower than the other. If the housing is damaged, you will not be able to properly adjust the dish rack height. This is an authentic OEM part sourced directly from the manufacturer and is sold individually.

This is an upper spray arm for a dishwasher. While the appliance is in use, the spray arm rotates while water travels through it to distribute water evenly throughout the dishwasher tub. This ensures the dishes are efficiently and properly cleaned. It measures approximately 19 inches long and is grey in color.

This mounting kit can be used on solid surface countertops.

Sold individually.

Measures level of soil in the water.

This lower door seal ensures a tight seal between the bottom of your dishwasher door and the tub, preventing leaks during operation. It is compatible with various Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Magic Chef dishwashers. If water is leaking from the front or bottom of your appliance, replacing this seal can resol...Read moreve the issue. After installation, close the door for several hours to ensure the seal seats properly for optimal performance.

This pump inlet grommet is a genuine OEM replacement part that is compatible with various models of dishwashers. It is made of rubber and has a diameter of approximately 2.5 inches. The grommet is used to create a watertight seal in the area between the inlet hose and the circulation pump. This prevents the dishwasher from leaking, and it...Read more also helps to absorb minor shocks and vibrations that occur while the dishwasher is running. It is normal for the grommet to wear down over time or become damaged from exposure to water, heat, and chemicals.

This genuine OEM thermostat is sourced directly from the manufacturer to ensure compatibility with your dishwasher model. The thermostat monitors and regulates the temperature of the dishwasher heating element. It is responsible for ensuring that the water temperature reaches the optimal level for effective cleaning while also helping to ...Read moreprevent overheating and potential damage to the internal components of the dishwasher.