JVM1190SYC01 General Electric Microwave - Parts

This light bulb is a 40 watt, 130-volt clear appliance light bulb that is manufactured to fit microwaves with small-base light bulb sockets. The light bulb illuminates the inside of the microwave while the microwave is running. You may need to replace this part if the existing one is burnt-out or broken. If the existing light bulb is brok...Read moreen, disconnect power to the microwave and remove the bulb base with a pair of needle nose pliers. This is a common wear item, so it is recommended to order a spare. These light bulbs are sold individually.

The secondary door switch is a simple on/off mechanism that stops the microwave from operating when the door is open (normally opened). The switch monitors the door latch position, and communicates whether the door is open or closed to the electrical control board. This door switch is approximately 1 inch long, and has 2 metal prongs cal...Read moreled terminals that extend out of its body. Common symptoms related to a faulty secondary door switch include: microwave will not turn/shut off, or the microwave will not heat properly. NOTE: Before you begin this repair, first make sure your microwave is unplugged, and that your capacitor is discharged. A capacitor stores large amounts of electricity even when your microwave is unplugged.

Unplug your microwave before attempting this repair. You will need to remove the grill, which is held into place by two screws at the top of the grill (open your microwave door before doing this). Remove the grill. Remove the screw on the left holding the control panel in place. Loosen the screw behind the panel. You should now be able to...Read more lift the panel up and pull forward to detach. You will find the door switch by removing the screws to detach the switch assembly. Press on the release tab to remove the middle switch. Disconnect the wire connector to release the old switch. The door switch is normally closed.

This diode has a 1/4" female connection and an eyelet.

This filter is used on over-the-range units that are not vented to the outside. These are also sold individually.

Introducing the GE High-Voltage Capacitor, designed for microwaves. This cutting-edge component operates at a potent 2100V and a capacity of 0.86 micro, embodying both performance and power. As an essential electronic device, this capacitor holds a substantial electrical charge within the high-voltage circuit of your microwave. With utmos...Read moret importance to safety, it is advised that a professional service technician performs the installation of this component as it can potentially retain a lethal electrical charge even when the microwave is unplugged. Trust in the quality and dependability of GE for your appliance repair needs. Embrace the efficiency of this 2100V/0.86 micro high-voltage capacitor, and let it enhance the functionality of your microwave.