Quick Question!

Have you ever purchased from PartSelect.com before?

Authentic Parts
Models > JES9800AAS

JES9800AAS Jenn-Air Range - Overview

Get Parts and Repair Help for JES9800AAS

If you know the range repair part you need, you can browse the list of all parts on the JES9800AAS, or you can search by name or part description. You can also find your part by where it is located on the JES9800AAS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JES9800AAS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JES9800AAS

[Viewing 6 of 6]
BLOWER ASSEMBLY (PLENUM)
BODY
CONTROL PANEL / TOP ASSEMBLY
DOOR / ACCESS PANEL (STL)
OVEN / BASE
WIRING INFORMATION
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$36.61
In Stock

Bake Element

This bake element, also known as an oven bake element, supplies heat for baking purposes. This part is located at the bottom of the oven. If you find little to no heat when baking,...

$11.48
In Stock

Grease Filter

This filter is made of metal and is intended for use with ranges and cooktops. Grease filters are an important but often neglected part of ranges. If the filter is full, your extractor fan will become nosier, and cause a bad odor to come from your range. Neglecting the grease filter can also pose a fire hazard in your kitchen. Regular maintenance and cleaning of the grease filter is important and will make the part work more efficiently and last longer. It takes about 30 seconds to replace your grease filter. While replacing the filter, take a minute to check for a grease buildup underneath, and clean out any drip-through grease. As per the manufacturer, if this filter is 1/2" less wide than the original, it will still function the same.

$29.74
In Stock

Long Oven Sensor

This long oven sensor is also commonly known as a temperature sensor. It is designed for use with ovens and ranges. It is similar to a thermostat; it measures and regulates the int...

$2.96
In Stock

Screw

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

$6.49
In Stock

Levelling Leg

This is a levelling leg for your oven, range, or stove. It is just under 3 inches long, is all black in colour, and is made entirely out of plastic. The levelling legs on your oven...

$44.96
In Stock

Door Gasket

The oven door gasket on your range functions as a seal between the warm interior of your oven, and the outside. It prevents heat from fleeing your oven when the door is closed. Before making any repairs to your oven you should make sure to wear work gloves to protect your hands, and give your oven time to cool. The only tool you will need to make this repair is a pair of needle nose pliers. This oven door gasket comes with built in retaining clips; if any retaining clips from your old gasket are left in the oven make sure to remove them before installing your new gasket.

$53.63
In Stock

Oven Rack

This is a replacement oven rack and it is designed for use with ranges and ovens. This is a genuine OEM replacement part. The rack provides a level and stable surface for cookware ...

$60.41
In Stock

Infinite Switch - 240V

This part is used for the 6" and 8" burners. Note: This part has been updated by the manufacturer. It may differ in appearance but will still function the same.

$66.33
In Stock

Inner Door Glass Pane

Glass only.

$46.20
In Stock

Dual Surface Burner Switch Kit

This switch is used to operate the dual surface burner.

Common Symptoms of the JES9800AAS

[Viewing 10 of 10]
Little to no heat when bak

Fixed by these parts

Show All
Element will not heat

Fixed by these parts

Show All
Oven not heating evenly

Fixed by these parts

Show All
Will Not Start

Fixed by these parts

Show All
Oven is too hot

Fixed by these parts

Show All
Touchpad does not respond

Fixed by these parts

Show All
Will not program

Fixed by these parts

Show All
Door won’t open after self...

Fixed by these parts

Show All
Door won’t close

Fixed by these parts

Show All
Little to no heat when bro...

Fixed by these parts

Show All

Replacing the Bake Element

Replacing the Grease Filter

Replacing the Long Oven Sensor

Replacing the Levelling Leg

Replacing the Door Gasket

Replacing the Oven Rack

Replacing the Inner Door Glass Pane

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replace Grease Filter

  • Customer: Gene from Washington C.H., OH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 515 of 521 people found this instruction helpful
Just a couple of minutes to left off the cover grid, left out the old filter and drop in the new one. read more

The element broke in two pieces after food dried on it.

  • Customer: Heather from Huntsville, AL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 146 of 150 people found this instruction helpful
First, I unplugged the oven. Then, I removed the two screws that hold the element in place. After that, I gently pulled the element toward the front of the oven until the wires were exposed. I disconnected the wires from the old element, removed the old element and then attached the wires to the new baking element. I gently pushed the new element back in... read more

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 122 of 141 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

All brand logos are trademarks of their respective owners.

The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.

Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.