EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

GLEF388GBA Frigidaire Range - Instructions

All Instructions for the GLEF388GBA
91 - 105 of 125

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Bake element broke off near connector
  • Rose from Crowley, LA
  • Easy
  • Less than 15 mins
  • Nutdriver, Pliers
unscrewed brace attached to element without any problem and secured the wire so that it would not fall behind liner. Connector was a bit hard to disconnect so asked my handyman to detach it - I was not familiar with this connection and did not want to break it - he did it w/o problems and attached the new bake element pronto. How easy can it get!
Was this helpful?
Thank you for voting!
The oven stopped working.
  • Joyime from Wolcott, CT
  • Really Easy
  • 15 - 30 mins
  • Nutdriver, Socket set
The part i replaced was very easy.I pulled the stove away from the wall and took the back pannel off. I then unpluged the electrical strip from the unit.There are two nuts holding the unit in place one at each end,there are also five wires on the right side of the unit you will have to mark them before you disconnect them. Then carefully peal the face off the old unit and reinstall on the one. Put the new unit in place, plugin the electrical strip,the five wires,reinstall the back cover,plugin your stove and your done. All this took about twenty minutes start to finish.
Was this helpful?
Thank you for voting!
inner glass uncleanable
  • Krista from Newtown, CT
  • Easy
  • 15 - 30 mins
  • Screw drivers
Took door apart, went online to partselect, ordered new glass, and put it back together. Oven looks like new. Makes sense to order the isolation as well when you do the repair
Was this helpful?
Thank you for voting!
oven took too long to heat up
  • JAONNE from GAFILED, NJ
  • Really Easy
  • 15 - 30 mins
  • Nutdriver
un bolted the 6 nut driver heads found probe wire un pluged it 1/4 turn from lock it was in and pull out replace slide in new probe 1/4 turn to lock it in place replace nut driver self tappers and test simple!!
Was this helpful?
Thank you for voting!
really bad ugly streaks inside of glass
  • John from Hemet, CA
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
open door,throw the door latches at the hinges and remove door. Take the out of the outer panel so you can separate the glasses. remove clip that hold the outer glass in place. I ordered a replacement glass as I never thought that it would come clean it looked so bad, but it cleaned up like new so I now have a spare glass for my oven door . Just reverse the way you take it apart to put it back together.
Was this helpful?
Thank you for voting!
Bake element flashed and left a hole in element. Element was red to blowout point.
  • Lamont from Columbia, TN
  • Really Easy
  • Less than 15 mins
  • Nutdriver
Removed power plug from outlet. Removed metal racks. Used 1/4" nut driver to remove screws. Carefully pulled element straight foreword. After wires were exposed they were carefully removed. Made sure wires stayed outside mounting hole. Put new element in made sure wires were secured to new element. Carefully push back on element to get wi res in place. Put screws in element. Start one screw then the other. Then tighten both screws. Plug power cord back into wall" or turn circuit breaker on if you used that option. Turn dial to bake element on and check for prerogative operation.
Was this helpful?
Thank you for voting!
Cracked inner oven door
  • Steve from Hollypond, AL
  • Easy
  • More than 2 hours
  • Pliers, Screw drivers
Removed outer glass first ,then worked my way thru to inner glass..
Was this helpful?
Thank you for voting!
Broken oven door glass
  • Joseph from Cranberry township, PA
  • Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers
I followed directions for replacement of the glass from the web. Replacement was simple and easy.
Was this helpful?
Thank you for voting!
The bottom heating element had stop working.
  • Nathaniel J. from Miami Gardens, FL
  • Easy
  • 30 - 60 mins
  • Nutdriver
I had order a replacement baking element to start, without trouble shooting the problem. When I had replaced the new bake element, set the oven to bake @ 350*F & watch for the baking element to heat up,it did not heat up. I waited for the oven to cool down,pulled the unit out & unpluged it from the receptacle.I removed the back cover,then I used my volt/ohm meter to check for contunity from the switch to both side of the element. Measured the ohms of the 3 bake elements,all good. Verfied that diodes were ok & there was no open resistors on the circuit board.No proble found. Put the back cover on, pluged the unit into the electrical outlet, pushed the unit back in placed, set the oven to bake @ 350*F, problem solved. My wife have bake several cakes & I cooked Sunday dinner using the oven. The real problem may have been an open circuit between the bottom bake elament & the switch. The repair was completed on 12/02/2012.
Was this helpful?
Thank you for voting!
inner glass door was broken
  • Norma J from Riverview, FL
  • Difficult
  • 30 - 60 mins
removed the door from the range. removed the 4 layers of glass and carefully set aside the unbroken ones. the 3rd and 4th glasses were held together with a metal frame which had to be dismantled. The old broken glass was rusted and hard to get out of the frame. It had to be cleaned thoroughly of broken glass and rust. the removal process could then be reversed to assemble the parts and re assemble the door to the front of the range
Was this helpful?
Thank you for voting!
broken inner glass
  • Neal from Warsaw, IN
  • Easy
  • 30 - 60 mins
  • Screw drivers
Removed oven door. Removed screws from bottom of door as well as handle screws. Remove inner panel to expose glass. Replaced glass panel and reverse steps. Very easy.
Was this helpful?
Thank you for voting!
inner oven door glass broken
  • Cheryl from Derby, NY
  • Really Easy
  • 30 - 60 mins
  • Screw drivers
I was unable to loosen the screws myself so I called my friends husband to help me. We watched the video together and followed the instructions. The door in the video was a bit different than mine but this repair was easy.
Was this helpful?
Thank you for voting!
Door glass cracked
  • Mike from Collegeville, PA
  • Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers, Socket set
Really straightforward - just took door off of the hinges and worked taking it apart until I got to the front glass that was cracked. Took it out and put the new piece in and reversed the process. Really easy and I got to clean each piece on the way back in to get rid of some spills.
Was this helpful?
Thank you for voting!
All Instructions for the GLEF388GBA
91 - 105 of 125