GEF365CHSA Frigidaire Range - Parts

The infinite burner switch controls the stove top eight-inch surface burner, which is the large surface element. If your surface element is not warming up, the element can be tested to determine whether or not it is defective. If your element is not defective, then it is more than likely that the infinite burner switch is the issue. Befor...Read moree you install the infinite burner switch you will need to unplug your range from the power supply, or shut off the home circuit breaker. The tools you will need to do this repair include a number one square head screwdriver and a pair of needle nose pliers.

This is a part for your range. This switch controls the stovetop surface burner. If you notice that your stove top is not turning on or is not adjusting to the corresponding desired heat, it is mostly likely due to the burner switch needing to be replaced. You will need a #1 square-head screwdriver and needle-nose pliers. Disconnect the p...Read moreower from the range. You will need to move the range out from the wall to remove the upper back panel to access to this part. This is an OEM genuine part.

This is a red indicator light lens for an oven that covers the indicator light for the surface element. The indicator light signifies when the element is on and heated. This part is sold individually. It is recommended to check other red indicator lights in case they need to be replaced because they often wear at the same rate. It is diff...Read moreicult to see the light without the red lens. This part does not include the light. If your light does not illuminate, you may want to consider ordering the light as well. Tools required for this repair are a 1/4 inch nut driver and a stubby Phillips screwdriver.

Sold Individually.

Sold individually. This knob accepts a D-shaped shaft.

A light or fan that responds only when its control is moved may have a worn rocker switch. This replacement switch mounts in the appliance panel and controls power to the assigned feature. Its exact job varies by model, so check the wiring diagram before installation. First inspect the bulb or fan, wiring, terminals, and power supply beca...Read moreuse another fault may be responsible. Turn off the circuit breaker and confirm the appliance has no power. Allow the cooking area to cool and wear gloves around sharp panel edges. Label each wire, avoid pulling on the wire itself, and make sure every terminal fits tightly during reassembly.

This part goes in front of the clock/timer to allow visual indication of where the buttons are on the oven. Example bake, broil & clean. Only available in white. Black version is no longer available.

Sold Individually. Pan Head Screw - 8-18ab X 0.375