FFHT2126LS3 Frigidaire Refrigerator - Instructions

Unboxed parts and snapped into place, no tools required . Good price, quick shipment---very pleased !

Easy shelf removal and replacement, just slide in place.

Door bins were easy to hook and snap into place.

Handle has a hook on one end and just two screws to secure at the other end.

Just put bottom. Door shelf in and slide top shelf back in

I simply removed the old broken shelf and clipped in the new one. Not a major project however the company went above and beyond due to a problem with the delivery of the part. I live in an 1,800 unit condo. Packages are delivered to a kiosk for pick up. FedEx showed the package was delivered but I did not receive it. When I called PartSelect to advise of the problem, they immediately refunded me for the part I didn't receive and sent another one which I received in a few days. I found the company to be very reliable and customer friendly. I will use them again should the occasion arise.

very simple--pull out damaged bin then snap new bin in. takes all of approximately 10-15 seconds.

Just slid it down into place.

Just snapped it in it was that easy

Just lay the new glass shelf into the groves. The shelf was too big and would not fit properly down into the groves.

opened box that part came in snpped it in place

Opened the door, aligned new shelf with the prods attached to door frame and then put it in.

Only thing we needed to do was to slide in the glass shelf into the grooves inside the refrigerator!!

Looked up model number online and found this site . Prices were reasonable and ordered the bin. It snapped right into place.

Unplugged refrigerator. Emptied freezer and removed ice maker and cover, need to unplug fan. Defrosted coils with hot water. Cut wires to thermostat as close to it ad possible to leave extra wire in case of an error. Stripped wire in new thermostat and put in shrink plastic then the wire crimp connector joining both light blue wires making sure wires were in before crimping them. Repeated with other dark blue wire. After used the heat gun to shrink the protective white tubing. The only thing i found not satisfying was tge tubing. It was too wide and too small. When i shrunk it did not cover the whole connector and was loose. I had to use a glue gun to cover both ends of each wire connector. Hope this helps other users.

I cut wires from bad thermostat and removed it . Stripped wires and crimped connectors on new thermostat and wires from old thermostat. Used heat gun to seal sleeves over connectors. Very helpful video from this site Thanks, you will be my go to parts supplier from now on!!!!!!!!!!!!

I slid and locked the new shelf in place, easy!