My Orders
- Home
- FEC36S8HSB
- Instructions
FEC36S8HSB Frigidaire Cooktop - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dual radiant burner kaput.
11 of 22 people
found this instruction helpful.
-
Michael from Spokjane Valley, AL
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers
Removed trim screws,(4) , lifted range top and removed the element after taking a picture of same. then disconnected the wires. I was upset because the new element had a different wire configuration. I put it in anyway in spite of your warning of not being able to return it if it didn't work. I fired it up and it did not work correct
... Read more
ly. After a couple of "...oh dear me." A few Hail Mary's and an educated guess I reversed two wires and gave it another smoke test. Well, kiss my ....! It works.
Read less
Was this helpful?
Thank you for voting!
Burner eye would only produce High Heat on all settings
9 of 28 people
found this instruction helpful.
-
scot from keller, TX
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Pliers, Screw drivers
Ordered a new Surface Burner Switch to replace the failed unit.
When I opened the burner lid, I could see the insulation on all the wiring for the burners had fallen apart and wiring was exposed. The wiring for all 4 burners was exposed as the insulation had deteriorated and fallen off over 80% of the circuits. It was just blind luc ... Read more k there was not a fire or an electrical failure on a grand scale. I replaced the wiring and burner connection assemblies as they also showed signs of age and deterioration.
Had the switch not gone bad, forcing me to look into the wiring assemble, there very likely would have been an electrical fire. In a 220 volt appliance, electrical fires are a lot more excitement than I need.
Scot Hooper
Keller Texas
When I opened the burner lid, I could see the insulation on all the wiring for the burners had fallen apart and wiring was exposed. The wiring for all 4 burners was exposed as the insulation had deteriorated and fallen off over 80% of the circuits. It was just blind luc ... Read more k there was not a fire or an electrical failure on a grand scale. I replaced the wiring and burner connection assemblies as they also showed signs of age and deterioration.
Had the switch not gone bad, forcing me to look into the wiring assemble, there very likely would have been an electrical fire. In a 220 volt appliance, electrical fires are a lot more excitement than I need.
Scot Hooper
Keller Texas
Read less
Was this helpful?
Thank you for voting!