EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

F22CW9 Frigidaire Freezer - Instructions

All Instructions for the F22CW9
76 - 90 of 95

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer would not keep running and the temperature was too warm.
  • Edmond from Carroll, NH
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
Followed the sites instructions. Empty the bottom part of the freezer. Remove the screws. Move the panel out of the way. Easily remove the old part and replace with the new. Put the panel and screws back in place. The freezer works.
Was this helpful?
Thank you for voting!
Coils not Defrosting and stopped freezing
  • Joseph from Yulee, FL
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
Upluged power pulled freezer out from wall removed the two screws that holds the defrost timer unpluged defrost timer pluged new timer in mounted new timer back with the two screws pluged freezer back in and job was complete. Freezer working fine.
Was this helpful?
Thank you for voting!
Fan in freezer quit
  • Dan from Woodstock, GA
  • Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers
This was an easy job. First remove the ice maker, if you have one. Mine was mounted with just two screws. Loosen these screws, unplug the power cord at the connector and then lift the ice maker off. Remove the light bulb cover and the light bulb, just so you dont break it. Remove two hex screws and the back cover can be removed. My fan wa s mounted in the middle of a bracket retained between two rubber bushingings. Just push the fan blad of the shaft and pull the motoer out. Dissonect the power cord at the connector. My moter was differant than the replacement on the mounting so with the removial of the two screws on the motor I was able to exchange the upper and lower cast motoer housings. Reverse the assembly process and you good. Mine is running great.
Was this helpful?
Thank you for voting!
Adjust the door hinge for new gasket.
  • Kinnett from Gaffney, SC
  • Easy
  • 1- 2 hours
  • Screw drivers
Loosened the screws, removed the old gasket. Cleaned contact area and installed the new gasket. Adjusted the door hinge and used a hair dryer to let the new gasket relax and seal.
Was this helpful?
Thank you for voting!
All Instructions for the F22CW9
76 - 90 of 95