EX130D10021 Subaru Engine - Parts

This gasket, also known as the oil drain plug gasket, is a ring-shaped, metal component used in outdoor power engines. It is supplied by the manufacturer and can be found at the bottom of the engine oil pan where the drain plug is installed. The gasket is responsible for sealing the area between the oil drain plug and the engine block to ...Read moreprevent oil from leaking during oil changes. Over time the gasket can wear down, corrode, or crack. If the gasket can no longer seal the area, oil will escape from the oil pan, leading to inadequate lubrication, increased friction, and engine damage. Before you begin the repair, drain the oil from the engine to prevent contamination. Use a wrench to loosen and remove the oil drain plug. Peel off the old gasket, and thoroughly clean the drain plug and oil pan surface. Install the new gasket and ensure that it sits firmly on the oil pan. Finally, reinstall the drain plug, and be careful to avoid overtightening it.

This is an authentic Subaru/Robin replacement part that has been sourced from the original manufacturer to be used with small engines. The oil seal is used to seal the area around the crankshaft where it exits the crankcase. This item is available as an individual replacement part, please see illustrated diagram for associative parts.

The governor shaft attaches to the governor lever and is made of metal. It is available as an individual replacement part. This genuine item is supplied by the original equipment manufacturer for use with Subaru and Robin engines. A wrench might be helpful during the installation of this part. This item may become bent or broken and will need to be replaced.

This is an authentic item that is supplied directly from the original equipment manufacturer for use with Subaru/Robin engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or a damaged governor gear cp that was installed on a new unit, please make sure to refer to the diagrams of your model...Read more for the correct location and application of this hardware. Keep in mind this high-quality component is made of durable plastic and is sold individually.

This is an authentic Subaru/Robin replacement part manufactured for use with small engines. The fuel filter fits in the fuel tank just under the cap. This fuel filter strains the fuel as it is poured into the tank. The fuel filter is sold individually.

It is a genuine OEM component which is specially produced for use with a Subaru / Robin engines that are commonly installed on a variety of lawn and garden equipment. This replacement part provides a tight seal for the float chamber body. Unfortunately, over time the material may wear out or get damaged eventually requiring a replacement....Read more Please make sure to check appropriate diagrams of your model for the correct application. It is made of a durable material and is sold individually. You will need a wrench to remove and resecure the bolt that secures it to the float chamber body.

This is an authentic OEM part directly sourced from the Subaru / Robin manufacturer. The plastic packing is compatible with many small engines. This item secures the cup to the cock body-a within the carburetor. This part is sold individually. A screwdriver is helpful in making the repair. Please refer to specific manual and diagrams for instructions.

This is an authentic OEM sourced replacement part used on a variety of Subaru/Robin engines. This part provides an air tight seal between a carburetor and an insulator. This part is made out of composite material and it is sold individually. You would need a wrench to complete a repair.

This replacement air filter element is specially manufactured for use on Subaru-Robin engines. It is a genuine OEM item, not an aftermarket alternative. Its purpose is to filter out dust and debris from contaminating the engine. This urethane foam filter is sold individually. Replacing this filter element is a very simple task that does...Read more not require any tools. • Remove the filter cover • Remove the old element • Place the new element in the housing • Secure the cover

This is a genuine Subaru and Robin replacement part for use in engines. The governor sleeve attaches to the governor gear. A hammer may be needed during the replacement of this part. It is made out of metal and will need to be replaced if it breaks. This item is sold individually.