DWS779R (Type 30) DeWALT Miter Saw - Parts

This is a genuine DeWALT replacement part. The sleeve is designed by the manufacturer for use in miter saws. This part is made of metal, and is generally used to allow the rod to move easily in the adjusting lever assembly. This part is sold as an individual replacement part.

This is an authentic DeWalt replacement part sourced from the original manufacturer for use with miter saws. The metal wrench holder is commonly used to store the blade wrench onboard of the miter saw. This wrench holder is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine DeWALT replacement part. The retaining plate is designed by the manufacturer for use in miter saws. This part is made of metal, and is used to secure the lock pin in the arm assembly. You may require a screwdriver or Allen wrench when replacing this item. This part is sold individually.

It is a genuine OEM sourced item that is specially made for use with DeWALT crosscut miter saws. This is an identical replacement for a missing or a faulty set screw that was originally installed on a new unit. Please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep ...Read morein mind this high-quality item is made of durable metal and is sold individually. You will need a Hex Key also known as an Allen wrench to secure or remove it.

This manufacturer-supplied part is made for use with DeWALT miter saws. It is a special clamp that is utilized to secure the cable. This is an identical replacement for a faulty or a missing component that was installed on a new unit. Refer to the diagrams of your model for the exact location and the correct application of this part. This...Read more high-quality clamp is made of durable metal and is sold individually. Note, the screw to secure it is sold separately. You will need a screwdriver to replace this part.

This is an original DeWalt replacement part manufactured for use with miter saws. This retaining ring is used with belt drive miter saws. The ring typically secures the bearing to pinion shaft which is driven by the belt and pulley. This retaining ring is sold individually, please see model diagram for additional parts of the blade drive assembly.

This manufacturer sourced replacement part is designed for use with Dewalt miter saws. It helps to distribute the pressure evenly and allowing parts to be secured safely. This is a standard hardware which has multiple applications based on your equipment, for the proper application please refer to diagrams of your model. This part is made of durable metal and it is sold individually.

This is a Genuine OEM sourced replacement part designed for use with a variety of Power Tools. It will have different applications based on your tool. This part is made out of Metal and it is Sold Individually. Requires a Torx Screwdriver to tighten or loosen this Screw.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling...Read moreu> - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

Read less