My Orders
DW5080U1 Rowenta Iron - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Unit would cycle on/off but defaulted to off frequently
2 of 2 people
found this instruction helpful.
-
GENE from NEW BRAUNFELS, TX
- Very Easy
- Less than 15 mins
-
Screw drivers
Unplug unit from a power supply. There is only one screw at the base/rest of the iron. Remove that screw. Then gently pry off that plastic base cap. Once removed, the wiring is exposed. Simply pull back on the harness portion that drops down into the handle. Secondly, the plug-in portion of the harness inside the base cavit
... Read more
y has two flat clips that "catch" the wiring from being pulled out of the handle. Simply take a small flat bladed screwdriver and slightly lift those two flat "catches". That will release the rest of the wire harness. Discard this wire harness and prepare to install the new one. First, slide the long wire portion down into the handle cavity until it stops. Second, press the other wire harness portion over it's two clips until you hear/sense that the two flat "catches" have secured this portion of the harness. Reattach base and secure with the screw you previously removed. Plug in and test by looking for Power-On light.
Read less
Was this helpful?
Thank you for voting!