Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is a genuine manufacturer sourced replacement part that is designed for Rowenta irons. If the cord is damaged it is important to replace it before continuing to use the unit. This durable rubber ...
This is an authentic Rowenta replacement part, sourced from the original manufacturer for use with irons. The special backheel cover is used to enclose the back end of the main housing. This backheel ...
It is a genuine item that is supplied directly from original equipment manufacturer for use with Rowenta irons. This replacement assembly which includes the front handle with control buttons and the p...
Unplug unit from a power supply. There is only one screw at the base/rest of the iron. Remove that screw. Then gently pry off that plastic base cap. Once removed, the wiring is exposed. Simply pull back on the harness portion that drops down into the handle. Secondly, the plug-in portion of the harness inside the base cavit
... Read morey has two flat clips that "catch" the wiring from being pulled out of the handle. Simply take a small flat bladed screwdriver and slightly lift those two flat "catches". That will release the rest of the wire harness. Discard this wire harness and prepare to install the new one. First, slide the long wire portion down into the handle cavity until it stops. Second, press the other wire harness portion over it's two clips until you hear/sense that the two flat "catches" have secured this portion of the harness. Reattach base and secure with the screw you previously removed. Plug in and test by looking for Power-On light.
