EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

DV203AES (XAA) Samsung Dryer - Instructions

All Instructions for the DV203AES
1 - 4 of 4

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dryer stopped heating
6 of 8 people found this instruction helpful.
  • Mark from WEST SUNBURY, PA
  • Really Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers
I purchased wholesale heater element with sensors. Couple wires and bolts to attach. Trickiest part is disassembling the dryer to remove the old heating unit. You-tube it; it's gold.
Was this helpful?
Thank you for voting!
The dryer was running just fine in all areas except there was no heat. The vent line was not plugged.
2 of 2 people found this instruction helpful.
  • David from RENTON, WA
  • Easy
  • 1- 2 hours
  • Pliers, Screw drivers
I firstly over-ordered parts. The general guidance is check one part and replace if bad, then check the next, etc. I only wanted to do the disassembly once so I ordered all the parts which were involved with generating heat. Turned out the heater duct assembly came with the thermal fuse and thermistor already installed, in addition to the heating element. Once I had the parts, I watched the video which was identified in my parts order. Then I started disassembly. I put screws from each step into their own little container so there was no mixing them up. Everything went exactly as shown in the video, except for the front panel containing the control board. My dryer was slightly different, but still easy to get out. When I had the drum out, the heater duct assemble was easy to remove, one screw only. I transferred connecters from the old duct to the new one-at-a-time to make sure there were no mistakes, then installed the new one with the single screw. Re-assembly went quickly. I plugged it in and, with some hesitation, set it to a short timed cycle and started it. After a few minutes, I hit pause and stuck my hand in the drum and it was warm! The dryer has continued to work since. Repair successful!
Was this helpful?
Thank you for voting!
Heating coil went ..
2 of 2 people found this instruction helpful.
  • Peter from TROY, NY
  • A Bit Difficult
  • 30 - 60 mins
  • Nutdriver, Screw drivers
Dryer was pretty easy to disassemble. The video helped, especially when re-routing the drive belt. Would definitely but from Parts Select again!
Was this helpful?
Thank you for voting!
high limit thermostat and heating element were bad.
1 of 2 people found this instruction helpful.
  • Paul from FIRESTONE, CO
  • Easy
  • 1- 2 hours
  • Screw drivers, Socket set
I would like to direct the attention to PartSelect instead of my repair. They were awesome in helping me to get my parts. I had called, a few minutes after the deadline for overnight shipping, the gentleman helping me, pushed the order through and I got my parts the next day, allowing me to repair my dryer. I have ordered several parts , for several different appliances, (all Samsung) and PartSelect has always come through for me. Excellent Customer Service!!
P.S. Don't buy Samsung appliances unless you want to get good at repairing them!
Was this helpful?
Thank you for voting!
All Instructions for the DV203AES
1 - 4 of 4