DP250 (Type 1) Delta Drill Press - Parts

Stiff movement, poor bit grip, or a seized chuck can make a drill press difficult or unsafe to use. This replacement chuck and key assembly holds drill bits firmly while the spindle turns. Check for dirty jaws, an incorrect key, bent bits, spindle runout, and worn bearings before deciding the chuck has failed. Match the replacement to the...Read more full tool model and type because similar-looking chucks may use different mounting systems. Disconnect electrical power before service. Use the correct removal tool, protect the chuck from falling, and clean the spindle and chuck socket thoroughly. Do not oil the mating surfaces. After installation, check bit alignment and operation at low speed.

It is an authentic OEM sourced item which is specifically produced for use with drills made by Delta and Black & Decker. The pin is made of metal and attaches to the table. During the installation process, a socket set might be needed to replace this part. It may become broken or bent and will need to be replaced. This is available as an individual replacement part.

This is a genuine Delta crank handle which is found on many drill press models. It will directly replace a worn, broken or missing handle. Please note that this handle does include the set screw for securing it in place. The handle will fit the Delta drill press models listed in the section below, but it is not guaranteed to fit any other tools.

Genuine Delta replacement part, this part with 2 part. The Delta 1310082 Spring With Housing is the part of the drill presses listed below that returns the drill chuck back to its original position after using the drill press. This part contains the spring and the spring housing.

This is a Genuine OEM Sourced replacement part used on Delta Power Equipment. This switch has a Plastic Body. Switches are a commonly replaced part in power tools, handling on/off operations. Because switches use mechanical internals, they will degrade and wear out over time, eventually requiring replacement. Please note the Switch Box an...Read mored the Cover are Sold Separately. To replace this switch you would need a Screwdriver. • First make sure the tools is not plugged in • Then you want to remove Screws used to hold two pieces of Housing Set together • Disconnect Wires from the old Switch and remove it from the Housing • Place the new Switch in the Housing and connect Wires to it • Reassembly the Housing

This is a genuine OEM replacement part designed for use with a variety of power tools. It is made out of metal and it is sold individually. It is a standard hardware which has multiple applications based on your tool. You would need a wrench to tighten/loosen this nut.