DP250 (Type 1) Delta Drill Press - Overview

It is an authentic OEM sourced item which is specifically produced for use with drills made by Delta and Black & Decker. The pin is made of metal and attaches to the table. During the installation process, a socket set might be needed to replace this part. It may become broken or bent and will need to be replaced. This is available as an individual replacement part.

This is a genuine Delta crank handle which is found on many drill press models. It will directly replace a worn, broken or missing handle. Please note that this handle does include the set screw for securing it in place. The handle will fit the Delta drill press models listed in the section below, but it is not guaranteed to fit any other tools.

This is a Genuine OEM Sourced replacement part used on Delta Power Equipment. This switch has a Plastic Body. Switches are a commonly replaced part in power tools, handling on/off operations. Because switches use mechanical internals, they will degrade and wear out over time, eventually requiring replacement. Please note the Switch Box an...Read mored the Cover are Sold Separately. To replace this switch you would need a Screwdriver. • First make sure the tools is not plugged in • Then you want to remove Screws used to hold two pieces of Housing Set together • Disconnect Wires from the old Switch and remove it from the Housing • Place the new Switch in the Housing and connect Wires to it • Reassembly the Housing

This is a genuine OEM replacement part designed for use with a variety of power tools. It is made out of metal and it is sold individually. It is a standard hardware which has multiple applications based on your tool. You would need a wrench to tighten/loosen this nut.