EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

DF15AUMALT Hardwick Freezer - Instructions

All Instructions for the DF15AUMALT
1 - 5 of 5

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
gasket had harden. frost was building up quickly
27 of 33 people found this instruction helpful.
  • LESLIE from TAPPAHANNOCK, VA
  • Easy
  • 30 - 60 mins
  • Nutdriver
the gasket peels back to reveal the approx 20 screwsholding gasket and door shelves. removed these. removed old gasket from door panel. new gasket needs to be stretched to get on door panel. align screw holes in door panel with screw holes in gasket. attached back to freezer door. this gasket did not seal securely when closing door. this gasket was installed on a cold day in a garage and may become more flexible as it warms up.
Was this helpful?
Thank you for voting!
No leveling legs
3 of 4 people found this instruction helpful.
  • stephen from montgomery, NY
  • Really Easy
  • Less than 15 mins
  • Wrench (Adjustable)
Ordered the leveling bolts, very fast shipping, parts correct as shown. Purchased a condo by the shore, frige had no levelers, they went in smoothly & was done in no time.
Steve
Was this helpful?
Thank you for voting!
Renters removed leveling legs from refrigerator. I don't know why!
2 of 4 people found this instruction helpful.
  • Don from Frankfort, KY
  • Really Easy
  • Less than 15 mins
I tilted the unit back enough to scew the new legs into the threaded holes.
Was this helpful?
Thank you for voting!
Pantry Drawer Cover keeps falling off, not held in place by End Cap Kit
1 person found this instruction helpful.
  • Gerald from TANEYTOWN, MD
  • Really Easy
  • Less than 15 mins
  • Nutdriver
I removed the 2 crisper drawers and the glass shelf directly above the Pantry Drawer. Removed the Pantry Drawer and Pantry Drawer cover so you have easy access to the Right-Hand End Cap. On the right-hand End Cap, there are 2 screws which hold the End Cap in place, use a 1/4 inch driver to unscrew the screws from the front of the cabine t on the End Cap and half-way in of the cabinet, leave the screws in their holes in the End Cap. Lift gently to get off a small plastic pin, and move the End Cap away from the Cabinet. You don't need to completely pull the End Cap out of the cabinet, it'll move more like a door opening. Place 2 washers on each screw and gently put the End Cap back into place, being careful NOT to jostle too much so the washers don't fall off the screws. You will need to gently lift the End Cap back in to place over the plastic pin. Hand-tighten the screws back into place with the 1/4 in driver. Remount the Pantry Drawer on the sliders. When you go to install the Pantry Drawer Cover, you will need to gently push on one of the pins to get the cover back into place. Put glass and crisper drawers back into place.

Test by gently pulling on the Pantry Drawer. If properly mounted, the pins will extend fully into the Cover and will keep it secure when opening the Pantry Drawer.
Was this helpful?
Thank you for voting!
All Instructions for the DF15AUMALT
1 - 5 of 5