DB3710DB Samsung Dishwasher - Instructions

Removed the bottom spray arm, the filter cover the filter ane the impeller. Then put it back together. Worked like a champ.

took off drain hose pulled out flapper on the pump side and installed new one then put everything back together

I pulled out the dishwasher a little to expose the screw on the striker, (located on top of the dishwasher. The annoying thing was, it wasn't a regular screw, so unfortunately I had to go out and buy a torx screwdriver (which cost more than the new striker). It would have been so much quicker, and cost effective, if it had been a normal s ... Read more crew. Anyway, I completed the job and pushed the dishwasher back into place.

I unplugged the dishwasher under the sink. I opened the dishwasher up and took out the 12 screws holding the inside door facing on. I gently moved the door facing down towards the dishwasher to reveal the door locking mechanism at the top of the door. I unplugged the mechanism and plugged in the new one. I put the door back together the s ... Read more ame way I had taken it apart. In all it took about 12 minutes. Works like a charm.

just snapped the wheels on. It took less than 10 minutes.

Install complete latch and handle assembly. Remove panel, disconnect wiring and install the assembly

eash as pie. snap them onto the piece of frame on the bottom rack and the problem is solved

I examined the arm on the floor of the dishwasher and found that it had collided with something sticking through the bottom of the lower rack. One of the jets on the tip of the arm, which was supposed to spray sideways to make the arm spin, was missing its top and now sprayed up. This put the arm off balance and kept it from spinning. I o ... Read more rdered a new arm from PartSelect. It arrived much sooner than I expected. With the pliers, I unscrewed the nut holding the arm on, replaced it with the new arm, and refastened the nut. The next time I used the dishwasher all the dishes on the bottom rack were clean.

Followed the video instructions. Couldn't have been easier. Bought 2 extras for the inevitable breakdown of others.

I haven't gotten to our rental to get the job done yet but it should go real easy because the broken one came off real easy these should go on just as easy. Thanks again for the parts

Remove lower basket. put nut on verticle shaft, turn clockise by hand, use pliers gently to secure and replave lower basket.

Ordered part #2099940. Removed existing gasket, cleaned the area and replaced it with new one - so simple. No tools required.

Popped the wheel part on the rack. No problem and the dishwaher was ready to go.

snapped it on to the rack shaft

I just followed another persons directions that was in the system already. He had a great idea by taking the new switches out of the new latch and replacing them with the old ones from the bad latch. The old switches are still good and it made for a simple repair. This way you didn't have to disconnect the wire from the switches and now y ... Read more ou have two new switches on hand. The old switch had a burnt spot on the connector.