CAV4000AWS Magic Chef Washer - Parts

The lid hinge on your washer is connected to the lid and allows it to open and close. If you find you cannot open or close the lid to your washing machine properly, you may need to replace the lid hinge. This lid hinge is an inch and a half long, all white in color, and it is made entirely of plastic. To complete this repair, you will nee...Read mored a Phillips screwdriver and a putty knife to remove the top of the washer, in order to access the screws that hold the lid hinge in place. Be sure to disconnect the power to the washing machine before beginning this repair.

This lid hinge pin allows a washing machine lid to pivot open and closed properly. The hinge pin may need to be replaced if the lid will not open or will not close. The part is white and made of plastic. This lid hinge pin is just over an inch long, is sold individually, and does not include the mounting screw (consider ordering mounting ...Read morescrew if it rusted or stripped). It is recommended to check the opposite lid hinge pin before ordering because hinges may wear at the same rate. Be sure to not tighten the mounting screw to pin too tightly to avoid breaking the new part.

This screw is less than an inch long. It is a metallic screw that is used for many clothes washers. Sold individually.

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

The lid switch kit is an assembly for replacing your washer lid switch. The function of this part is to detect if your washer lid is open or closed. If it detects that it is open it will prevent the washer from rotating and agitating until it is closed. This kit includes the bracket, actuator, switch, screws, and wire harness. To complete...Read more this installation, you will need a number two Phillips screwdriver, and a 5/16 nut driver. Before beginning this repair, make sure the power supply to your washer is disconnected. In order to install this part, you will need access to the rear of the unit.

This bumper cushions the washer door from the cabinet. They are sold individually.

Sold individually.