AS23 Amana Refrigerator - Parts

This right side shelf support is just over an inch long. It is all white in color and it is made entirely of plastic.

This mount is used to connect the handle and trim together. Sold individually.

This is the replacement ice maker auger and crusher blade assembly for your refrigerator. It is approximately 15 inches long and 7 inches wide. The ice maker auger sits within the ice maker assembly and rotates to push the ice from ice container into the dispenser chute. If your ice maker bucket is full, but ice is not being dispensed, it...Read more is an indication that the auger is damaged. Be sure to disconnect power from the refrigerator before you repair the auger. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Sold individually.

Sold individually.

This part is the replacement ice chute door for your refrigerator/freezer. It is a round, black part that is approximately 2 ½ inches in diameter. The dispenser ice chute door opens to let ice through when dispensing into a glass or some other container. If the chute door is broken, your refrigerator may not be able to dispense ice proper...Read morely. Be sure to disconnect the power from your refrigerator before you begin this repair. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

This wheel is sold individually. It is located on the bottom of the refrigerator.

This drip tray, also known as an overflow grille, is a manufacturer-approved replacement part for your refrigerator. The drip tray catches drips of water from the ice and water dispenser. To replace this part, simply pull out the existing overflow grille, and slide the new one into place.

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

This crushed ice wheel is five inches in diameter. It is beige in color and is made of plastic.

This part is the replacement shelf support for your refrigerator/freezer. It is made of white plastic and is approximately 1 inch by 1 inch. The shelf support attaches to the side of your refrigerator wall and supports the shelf. If your shelf is sagging or will not stay in place, you may need to replace the support. To replace the suppor...Read moret, use a wrench to turn the support clockwise until you can use a flat blade screwdriver to pop it out. Push the new support into the hole left by the old one until it is flush with the liner, then use the wrench to turn it clockwise until it locks in. This part is sold individually and is and OEM part.